BELT DRIVEN
(35
AMP) BATTERY CHARG-
ING
ALTERNATOR (Optional)
This information is presented for field useonly. Major
repair should be done in the shop.
Brush Assembly Removal
Remove brushes as follows:
1.
Remove three screws which fasten voltage
2.
Disconnect regulator leads and remove regulator.
3.
Remove two screws on phenolic coverand lift out
4.
Pull
brush assembly straight
up
and lift out.
5.
Reverse procedure for assembly (Figure
48).
regulator to alternator.
cover and gasket.
Brush Assembly Tests
Test brush assembly as follows:
1.
Connect an ohmmeter or test lamp
(12
volts) to
the field terminal and to the bracket. The test
lamp should not light or resistance reading should
be high (infinite). If not, there is a short and the
assembly must be replaced.
2.
Move one ohmmeter lead from the bracket to
insulated brush. Use an alligator clip directly on
the brush. Be careful not to chip
it.
Resistance
reading should be zero (continuity).
3.
Connect ohmmeter leads to the grounded brush
and the bracket. Resistance should be zero
(con
ti
nu ity).
VOLTAGE REGULATOR
MOUNTS
HERE
FIGURE
48.
OPTIONAL, BATTERY CHARGING,
EXTERNAL ALTERNATOR
47
Redistribution or publication of this document,
by any means, is strictly prohibited.
To Next Page
Loading...
