13
CHANGING VOLUME LOCK
The One ForAll 4 Device Universal Remote Control is set at the factory for
independent volume control of each selected device.However,you may
change the Volume Lock setting to Global Volume Lock so that a device’s vol-
ume will be locked to one mode (e.g.,to control TV volume in all other
modes).After that,if desired,you can perform
Individual Volume Unlock on a
selected device to set its volume control for independent operation.
Locking Volume Control To One Mode
(Global Volume Lock)
1. Press and hold SET until the LED (red light) blinks twice,
then release SET.
2. Enter
9 - 9 - 3 and then press any mode key once (e.g.,TV).
The
LED will blink twice.
3. Now, when you press
VOL+,VOL -,or MUTE, the volume of
the selected device (e.g., TV) will be controlled,regardless
of the mode you have selected.
Unlocking Volume Control For A Single Device (Individual Volume
Unlock)
1. After performing GlobalVolume Lock (above),press a desired
mode key where you want volume to be unlocked (e.g.,
DVD) and controlled within its own mode.
2. Press and and hold
SET until the LED (red light) blinks twice,
then releaseSET.
3. Enter
9 - 9 - 3 and then press VOL - once.The LED will blink
four times.
4. If desired,repeat steps 1 through 3 (of this section) for
each device that you want volume to be unlocked.
5. Now, after you select a device that has volume unlocked
(e.g.,
DVD),pressing VOL+, VOL -,or MUTE will control the
device’s volume only in its own mode.
Unlocking All Volume Control (Restoring Default Setting)
NOTE: Performing these instructions will restore independent volume control for all pro-
grammed devices (e.g., TV volume control in TV mode,VCR volume in VCR/PVR mode,
etc.).
1. On the remote control, press and hold SET until theLED (red
light) blinks twice,then release SET.
2. Enter
9 - 9 - 3 and then press VOL+once.The LED will
blink four times.
URC4220 manual booklet:WALLB4P manual booklet 4/13/09 3:47 PM Page 13
To Next Page
Loading...
Need help?
General
