14
3. Volume will again be independently controlled according
to its default states for all programmed devices.
CLEARING CUSTOM PROGRAMMING
The One ForAll 4 Device Universal Remote Control contains an Operational
Feature Reset
program.
If desired,you can use it to clear custom programming,except your setup
codes and reassigned device keys,and reset them to original factory set-
tings.Also see
Restoring Factory Default Settings as below.
IMPORTANT: Executing this program will erase all your custom settings for
Power Macro, Favorite Channels, and Volume Lock.
1. Press and hold SET until the LED (red light) blinks twice,
then release
SET.
2. Enter
9 - 8 - 0.The LED will blink twice.The remote control
will return to normal operation.
RESTORING FACTORY DEFAULT SETTINGS
The One ForAll 4 Device Universal Remote Control also contains a Factory
Reset
program that you can use to reset all custom settings and setup codes
to original factory settings.Also see Clearing Custom Programming as above.
IMPORTANT: Executing this program will erase all your custom settings for
Power Macro, Favorite Channels,Volume Lock, Reassigned Devices, and all
device settings.
1. Press and hold SET until the LED (red light) blinks twice,
then release SET.
2. Enter
9 - 8 - 1.The LED will blink twice.The remote control
will return to normal operation.
URC4220 manual booklet:WALLB4P manual booklet 4/13/09 3:47 PM Page 14
To Next Page
Loading...
Need help?
General
