32
EN
Inserting the batteries in the remote control
• Push down the battery compartment cover and slide the cover off to open
the compartment.
• Insert one CR2025 battery according to the polarity markings (+ and -) in
the compartment and on the battery.
• Place the lid in the compartment, press it down gently and slide it inwards
until it clicks into place.
Note: If the remote control is not used for a long time, the battery may
become weak and the remote control may not work. If this happens,
replace the battery with a new one. Do not expose the battery of the
remote control to excessive heat such as sunshine, re or the like.
Setting the time
In standby mode, press and hold the TIME key and the time display ashes.
Press the VOL- /Hour and VOLUME +/MINUTE buttons to set the current
time.
RADIO
Note: When searching for stations or listening to radio stations, no
frequency is shown on the display.
Automatic station search
You can use the Scan function to automatically search for new digital radio
stations and remove inactive stations.
Press and hold the PLAY / PAUSE / FM SCAN button on the stereo system or
on the remote control for 2 seconds to select [Scan]. The number of stations
found is displayed during the automatic station search. When the automatic
station search is nished, the last station listened to is tuned in. If the last
station listened to is no longer available, the rst station in the alphabetical list
is set.
To set a particular radio station manually, press the
/ button on the
stereo system or on the remote control repeatedly.
To Next Page
Loading...
