EasyManua.ls Logo

OneProd FALCON - Chapter 1: General Presentation; 1.1 Introduction and Safety

OneProd FALCON
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
Brand of ACOEM
BATTERY
Do not use any other battery than type PIL1133 designed for FALCON and
labelled 01dB-Metravib WILPA 2344A.
Do not open or dismount the battery pack. The pack includes essential safety
protections and assembly that should in no event be modified.
The battery pack can only be replaced for maintenance purposes. The
operating lifetime of the pack is long enough to guarantee a full day of
continuous work. The pack shall not be changed periodically to artificially
increase its operating lifetime. The pack is not designed for this operating
mode, which would lead to dangerous mechanical wear.
Do not short circuit the terminals of the battery connector (note: for safety
reasons, the battery pack is equipped with an internal non resettable fuse. A
short circuit would make the battery pack unusable).
Respect the voltage, current and temperature ranges listed on the battery
label.
Do not exert excessive mechanical pressure on the battery pack.
Do not expose the battery to water or condensation.
Do no place the battery into fire or close to any other temperature source (>
70°C). This action may cause overheating, even start a fire. This type of use
may also lead to degraded performances and to a significantly reduced
lifetime for the battery.
Immediately disconnect the battery and the charger in the event of one of the
following situations:
o unusual odour
o unusually high temperature

Other manuals for OneProd FALCON

Related product manuals