9
MAINS POWER SUPPLY BLOCK
The external power must be non-dangerous and energy limited as explained
in Sections 6.3 and 9.4 of the IEC61010 standard.
The power supply is the main disconnecting device in the system and, as
such, should remain always perfectly accessible and disconnectable.
Only use charger ZDL1201500 to power up and recharge FALCON.
The mains power block should only be used away from rain or any other
water splash.
FALCON should be used away from rain or any other water splash when
connected to the mains power block.
Comply with the network power supply specifications (listed on the charger)
for the power supply of the mains block: Input: AC 100-240V 50/60Hz
The power supply shall not be used in an environment with a temperature
higher than 35°C.
During charging, the operator shall limit the presence of flammable products
next to FALCON and the mains power block.
To connect AC power, open the hatch computer, plug the jack of the block onto the
socket, then connect the power to the electrical outlet. Proceed in the reverse order to
disconnect.
HEADPHONES/MICROPHONE
Before connecting the plug of the headphones, set the volume to the
minimum.
Avoid listening to extremely high volumes that can damage your hearing
irremediably.
Avoid wearing headphones during dangerous operations.
To Next Page
Loading...
