OneTouch Select - Caring for Your System

22
CARING FOR YOUR SYSTEM
 Caring for your system
Replacing the battery
Your OneTouch® Select™ Meter uses one 3.0 Volt CR 2032 lithium battery (or equivalent).
Replacement batteries can be found in most stores where batteries are sold. Your meter
comes with the battery already installed.
See Troubleshooting in Section 8 for information on when to change the meter battery.

Remove the old battery
Start with the meter o. Open the battery door and pull up on the battery ribbon.

Insert the new battery
With the “+” side facing up toward you, place the battery in the compartment within the fold of the ribbon.
Push the battery until it snaps into the battery clasp. Insert the two battery door tabs into the matching holes
on the meter, and push down until you hear the door click into place.
If the meter does not power on after you have replaced the meter battery, check that the battery is correctly
installed with the “+” side up. If the meter still does not power on, call Customer Service.

Check your meter settings
Removing the meter battery will not aect your stored results. However, you may need to re-set your meter settings.
See Setting the meter language, date and time in Section 2.

Dispose of the battery
Dispose of batteries according to your local environmental regulations.
Meter battery
 WARNING: To avoid a possible shock, Do Not change the battery while
the meter is connected to a computer with the OneTouch® Interface Cable.
Meter battery