3. Get ready to transfer readings
Make sure that the meter is turned off. Connect the OneTouch
®
Interface
Cable to the COM or USB port on your computer. Then connect the other end
of the cable to the meter data port.
4. Transfer data
Follow the instructions provided with OneTouch
®
DMS to download results
from the meter.
Once the command to start the download is sent from the computer to
the meter, the meter display will show “PC” indicating that the meter is in
communication mode. You will not be able to perform a test when the
meter is in communication mode.
Reviewing past results and averages
Interface
cable
37
To Next Page
Loading...
