OneTouch ULTRA2 User Manual

Before you begin
Before using this product to test your blood glucose, carefully read this User Guide and the inserts that come with the OneTouch® Ultra®
Test Strips and OneTouch® Ultra® Control Solution. Take note of warnings and cautions throughout this User Guide, which are identied
with . Many people nd it helpful to practice the test with control solution before testing with blood for the rst time. See Section 6,
Control solution testing.
Intended use
The OneTouch® Ultra® 2 Blood Glucose Monitoring System is intended to be used for the quantitative measurement of glucose (sugar) in
fresh capillary whole blood. The OneTouch® Ultra® 2 System is intended for use outside the body (in vitro diagnostic use) by people with
diabetes at home and by health care professionals in a clinical setting as an aid to monitor the eectiveness of diabetes control. It should
not be used for the diagnosis of diabetes or for testing newborns.
Test principle
Glucose in the blood sample mixes with special chemicals in the test strip and a small electric current is produced. The strength of this
current changes with the amount of glucose in the blood sample. Your meter measures the current, calculates your blood glucose level,
displays the result, and stores it in its memory.
NOTE: If you have any questions about your OneTouch® Ultra® 2 Blood Glucose Monitoring System, contact LifeScan Customer Service at
1 800 227-8862 (7 days a week, 8 a.m. - 10 p.m. Eastern Time).

OneTouch ULTRA2 Specifications

Power

meter power source	One replaceable 3.0 Volt CR 2032 lithium battery
backlight power source	One replaceable 3.0 Volt CR 2032 lithium battery
battery ratings	2 x 3.0 V d.c., 60 mA

Operating Environment

temperature range	6–44°C
relative humidity range	10–90%
altitude range	up to 3048 metres

Weight and Dimensions

weight	42.5 grams
size	7.92 x 5.72 x 2.29 cm