27
TROUBLESHOOTING AND DETAILED INFORMATION ABOUT YOUR SYSTEM
Electrical and safety standards
This meter complies with CISPR 11: 2003, Class B (Radiated Only). Emissions of the energy used are low and not likely to cause interference
in nearby electronic equipment. The meter has been tested for immunity to Level 3 electrostatic discharge as specied in IEC 61000-4-2.
This meter has been tested for immunity to radio frequency interference over the frequency range 80 MHz to 2.5 GHz at 3 V/m as specied in
IEC 61000-4-3.
Degree of protection rating: IP32
CAN/CSA C22.2 61010-1:04, UL 61010-1:04, IEC 61010-1 and IEC 61010-2-101.
Technical specications
Reported result range 20–600 mg/dL
Calibration Plasma-equivalent
Sample Fresh capillary whole blood
Test time 5 seconds
Assay method Glucose oxidase biosensor
Meter power source One replaceable 3.0 Volt CR 2032
lithium battery (or equivalent)
Backlight power source One replaceable 3.0 Volt CR 2032
lithium battery (or equivalent)
Unit of measure mg/dL
Memory 500 blood glucose or control solution
test results
Automatic shuto 2 minutes after last action
Size
3.12 x 2.25 x 0.90 inches
or 7.92 x 5.72 x 2.29 cm
Weight Approximately 1.5 ounces
or 42.5 grams, with batteries
Operating ranges Temperature: 43–111°F
Relative humidity: 10–90%
Altitude: up to 10,000 feet
or 3,048 meters
Hematocrit: 30–55%
Battery ratings 2 x 3.0 V d.c., 60 mA
(2 x CR 2032 batteries)
direct current
C US
To Previous Page
Loading...
Need help?
Power
Operating Environment
Weight and Dimensions
