Onkyo A-9510 - Page 2

Thank YOU for your purchase of the Onkyo A-
9510 Amplifier. e This apparatus complies with requirements of EC directiue 87/
Please read this manual thoroughly before making con- 308/BEC.
nections and turning power on.
Following the instructions in this manual will enable you
to obtain optimum performance and listening enjoyment
from your new A-9510.
Please retain this manual for future reference.
e@ For models having a power cord with a polarized plug.
CAUTION: To PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
Features
3
e Sur les modéles dont la fiche est polarisée.
@ Plenty of Clean Power ATTENTION: PouR EVITER LES CHOCS ELEC-
With
60
watts
per
channel
into
8
ohms,
20
Hz
to
20
kHz,
TRIQUES,
INTRODUIRE
LA
LAME
LA
PLUS
LARGE
DE
LA
;
0.06%
THD
(Dynamic
power:
130
watts/ch
into
4
ohms),
FICHE
DANS
LA
BORNE
CORRESPONDANTE
DE
LA
you'll
have
ample
power
to
drive
virtually
any
speakers,
and
PRISE
ET
POUSSER
JUSQ’AU
FOND.
produce dynamically rich music, even at low volume levels.
& Simple, Direct Signal Paths
To further reduce the chances of noise or interference from
entering the signal, the signal paths were made as short, direct
and
simple
as
possible.
e
Replacement
and
mounting
of
an
AC
plug
on
the
power
supply
@ Discrete
Output
Stage
Amplifiers
cord of
this
unit
should
be
performed
only
by
qualified
service
Rather than inexpensive hydrid IC “power packs” found in personnel.
some conventional amps, your A-9510 uses costly, discrete e@ IMPORTANT: The wires in the mains lead are coloured in
output stage amplifiers to drive each channel. In conjunction accordance with the following code:
with the heavy-duty transformers and large chemical capaci- Blue: Neutral
tors, they make it possible to drive low-impedance loads. Brown: Live
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the termi-
nals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the termi-
M@ Heavy-duty speaker binding posts that can handle nal which is marked with the letter L or coloured red.
cable as thick as 5.5 mm in diameter
@ Charging noise filters
M@ Gold-plated CD inputs
@ High Quality Remote Control System
The low-noise, (RE system-cor: natible remote has fine posi-
tioning. It also has a self-cleanit_, system where contact points
are polished by the rotation 01 the input selector when the
power is turned on.
Supplied accessories
1 Remote control
2 Batteries (size AA, R6, or UM-3)
1 Remote control cable
ee CAUTION
“TO
REDUCE
THE
RISK
OF
FIRE
OR
ELECTRIC
SHOCK,
RISICORELECTRIC
SHOCK
DO
NOT
EXPOSE
THIS
APPLIANCE
TO
RAIN
OR
MOIS-
DO
NOT
OPEN
TURE.”
@ The lightning flash with arrowhead symbol,
CAUTION: within an equilateral triangle, is intended to alert
“TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT the user to the presence of uninsulated “danger—
REMOVE COVER (OR BACK). NO USER-SERVICEABLE ous voltage” within the product’s enclosure that
PARTS INSIDE. REFER SERVICING TO QUALIFIED SER- may be of sufficient magnitude to constitute a
VICE
PERSONNEI..”
risk
of
electric
shock
to
persons.
The
exclamation
point
within
an
equilateral
tria—
gle is intended to
alert
the
user
to the
presenceof
important
operating
and maintenance
(servicing)
instructions
in the
literature
accompanying
be
appliance,