Onkyo A-R700

A-R700
t
stem code input terminal.
17} PE2 PLAYER | PLAYER control output terminal. Active ”L”.
Output "H” for 200ms if remote control K64
code is input when INPUT SELECTOR input
ie is PHONO.
18 | PE3 POFF This is the input terminal for detection of —
the power failure.
Active "H”.
Connect to Vss.
19 [TEST [TEST ~ [LSI test tenninal.
20 VSS VSS Ground terminal.
Connect to Vss.
21 OSC1 OSC1 Connect to the 4.00MHz ceramic oscillator.
22 OSC2 OSC2
23 RES RES _ System reset terminal. Active ”L”.
24 | PFO REM IN | Remote control signal input terminal.
Active "L”.
The phkoto-sensor output is connected to this
terminal.
25. ! PFI KO - Key input terminals. Active "H”. i
26} PF2/SCK ! Kl
PF3/INT | K2 at
| PGO KSO Key scan output terminals. Active "L”.
PG1 KS]
PG2 KS2
PG3 KS3.
32. | PIO DAT | Input selector mdicator output terminal.
a3 | PIl AUX-1 Active "L”, i
34 | PI2 TUNER
35 PI3 CD
36_—| Pja | TAPE-2
37 PJl : TAPE-1
38 Pj2 |} PHONO
39 =| Pye MUTING | Muting control output terminal. Muting on "L”,
40 VDD VDD Power supply terminal. (+5V)
41 |} PAO DIGB/AUX-2 | Input selector indicator output terminal.
| i Active "L”. [
42 {| PAl DIGA/MODE | AUX-2, MODE="L”, |
LB1638 (Motor drive) Tauth Table
ae /INi1] IN 2|ouT1/our2| ~— ai
H L H L |/NORMAL!
L H H_ |REVERSE
H H
L i
ae