Need help?Do you have a question about the Onkyo CP-1037F and is the answer not in the manual?
Measure insulation resistance between power supply cord plug and chassis using 500V tester.
Adjust turntable tonearm's return position using the eccentric pin on the tonearm base.
Adjust turntable tonearm's lead-in position by turning the eccentric pin clockwise or counter-clockwise.
Adjust turntable speeds (33-1/3 rpm and 45 rpm) using VR102 and VR101 potentiometers.
Set tonearm height to 12±1mm between stylus tip and platter mat using lifter plate screw.
To Next Page
General
