Need help?Do you have a question about the Onkyo CP-1037F and is the answer not in the manual?
General| Speeds | 33-1/3, 45, 78 rpm |
|---|---|
| Motor | DC Servo Motor |
| Overhang | 15 mm |
| Frequency Response | 20 Hz - 20 kHz |
| Platter | 300mm Aluminum Die-cast |
| Tonearm Type | Static Balance |
| Tonearm | S-shaped |
| Cartridge Type | MM |
| Output Level | 2.5 mV |
| Type | Belt-drive turntable |
| Signal to noise ratio | 70 dB |
Measure insulation resistance between power supply cord plug and chassis using 500V tester.
Adjust turntable tonearm's return position using the eccentric pin on the tonearm base.
Adjust turntable tonearm's lead-in position by turning the eccentric pin clockwise or counter-clockwise.
Adjust turntable speeds (33-1/3 rpm and 45 rpm) using VR102 and VR101 potentiometers.
Set tonearm height to 12±1mm between stylus tip and platter mat using lifter plate screw.
To Next Page
