52
Using the Timers
—Continued
Once a timer has been programmed, you can turn it on or
off as necessary. For example, while you’re on holiday,
you may want to turn off the timer you use as an early-
morning alarm.
Turning Timers On and Off
1
Press the [TIMER] button repeat-
edly to select timer 1, 2, 3, or 4.
When a timer has been programmed, its
number appears on the display.
2
Use the Previous and Next [ ]/
[] buttons to select Timer On or
Timer Off.
After a few moments, the previous dis-
play reappears.
/
TIMER
ENTER
MENU/NO/
CLEAR
or
Checking Timer Settings
1
Press the [TIMER] button repeat-
edly to select timer 1, 2, 3, or 4, and
then press [ENTER].
2
Press [ENTER] repeatedly to see
all of the timer’s settings.
Notes:
•You can change the settings by using
the Previous and Next [ ]/[ ]
buttons.
• If you change the settings of a timer
that is off, that timer will be turned on.
If you don’t change any settings, the pre-
vious display reappears.
To return to the previous display at any
point in this procedure, press the
[MENU/NO] button.
CR515,315En.book Page 52 Wednesday, June 7, 2006 2:36 PM
To Next Page
Loading...
Need help?
General
