Setting the Clock
36
Use the following procedure to set the clock.
1
Press the [TIMER] button repeatedly
until “Clock” appears.
2
Press [ENTER].
3
Use the
[ ] / [ ] buttons to
select the day of the week.
You can select: SUN, MON, TUE, WED
THU, FRI, or SAT.
4
Press [ENTER].
Tip:
To change the time format between 12-hour
and 24-hour, press the [DISPLAY] button.
5
Use the remote controller’s number
buttons to enter the current time.
You can also use the [ ] / [ ]
buttons.
Use the remote controller’s [ > 10] button
to select A.M. or P.M.
6
Press [ENTER].
The clock is set and the second dot starts
flashing.
Displaying the Day and Time
To display the day and time, press the remote
controller’s [CLOCK CALL] button. Press the button
again or perform another operation to cancel the time
display.
If the CD receiver is on Standby, the day and time
will be displayed for 8 seconds.
While the CD receiver is on, the day and time are
displayed continuously.
To Next Page
Loading...
