Onkyo CR-505DAB

29
Using the Radio—Continued
With the Auto Preset function you can automatically preset
all the FM stations available in your area.
1 Press the [FM] button.
2 Press the [MODE] button.
3 Use the [ ]/[ ] buttons to display “Pre-
set Edit,” and then press the [ENTER] but-
ton.
4 Use the [ ]/[ ] buttons to display “Auto
Preset?,” and then press the [ENTER] but-
ton.
Auto Preset function starts.
The Auto Preset function scans the FM band from low
to high, presetting up to 30 stations with strong signals.
Note:
All previously stored presets will be overwritten when the
Auto Preset function is used again.
Using the buttons on the CR-505DAB:
1. Use the [INPUT] button to select FM.
2. Press the [MENU] button.
3. Turn the [ ] control until “Preset Edit” appears on
the display and then push the [ ] control.
4. Turn the [ ] control until “Auto Preset?” appears
on the display and then push the [ ] control.
You can preset up to 40 of your favourite AM and FM radio
stations.
1 Tune into the station that you want to store
as a preset.
2 Press the [MODE] button.
3 Use the [ ]/[ ] buttons to display “Pre-
set Edit,” and then press the [ENTER] but-
ton.
4 Use the [ ]/[ ] buttons to display “Pre-
set Write?,” and then press the [ENTER]
button.
The preset number flashes.
5 While the preset number is flashing, use
the [ ]/[ ] buttons to select a preset
number from 1 to 40.
You cannot choose any preset number that has already
been registered for either the FM or AM station.
6 Press the [ENTER] button to store the sta-
tion.
The station is stored and the preset number stops flash-
ing.
Repeat this procedure for all of your favourite radio
stations.
Note:
When the CR-505DAB is tuned into a station that’s trans-
mitting PS (Program Service Name) RDS information, the
station’s name will be displayed instead of the frequency.
Using the buttons on the CR-505DAB:
1. Tune into the station that you want to store as a preset.
2. Press the [MENU] button.
3. Turn the [ ] control until “Preset Edit” appears on
the display and then push the [ ] control.
4. Turn the [ ] control until “Preset Write?” appears
on the display and push the [ ] control.
5. While the preset number is flashing, use the [ ]
control to select a preset number from 1 to 40.
6. Press the [ ] control to store the station.
You can select previously stored presets as follows.
Using the CR-505DAB
1 Turn the [ ] control to select presets.
Using the remote controller
1 Use the PRESET [ ]/[ ] buttons to
select presets.
Presetting FM Stations Automatically
Presetting Stations Manually
/
/
/
/
Selecting Presets
/
/
/
/
/
/
/