Onkyo CR-L5

25
Other Functions
With this function you can temporarily mute the output of
the CR-L5.
1
Press the remote controller’s [MUT-
ING] button.
The output is muted and the MUTING indicator flashes
on the display, as shown.
2
To unmute the CR-L5, press the [MUT-
ING] button again, or adjust the
remote controller’s volume [ ]/[ ]
buttons.
The output is unmuted and the MUTING indicator
goes off.
Note: The Mute function is cancelled when the CR-L5 is set
to Standby.
You can adjust the display brightness as follows.
1
Press the [DIMMER] button repeatedly
to select: dim, dimmer, or normal
brightness.
With the Bass and Treble functions you can adjust the tone
of the sound to your personal preference.
1
Use the remote controller’s [TONE]
button to select “Bass” or “Treble”.
2
Use the remote controller’s Up/Down
[ ]/[ ] buttons to adjust the bass or
treble.
The bass and treble can be adjusted from –10 to +10 in
increments of 2.
3
When you’ve finished, press the
[ENTER] button.
You can temporarily bypass the Bass and Treble func-
tions by using Direct mode.
In Direct mode, the bass and treble tone circuits are
bypassed, creating a shorter signal path for a purer sound.
1
Press the [DIRECT] button.
Direct mode is turned on and the DIRECT indicator
lights up.
2 To turn off Direct mode, press the
[DIRECT] button again.
The DIRECT indicator goes off.
Note: If you press the remote controller’s [TONE] button
while Direct Mode is on, Direct mode will be cancelled.
Muting the CR-L5
Adjusting the Display Brightness
ON STANDBY
ENTER
TONE
TIMER
DIRECT
SLEEP VOLUME
UP
DOWN
CLOCK CALL
DIMMER DISPLAY
CDR
C
D
TAPE
PLAY MODE
REPEAT
CLEAR
MUTING
12
▼
▲
3
456
789
▲
▼
INPUT
10/0
>
10
ENTER
DIRECT
TONE
MUTING
DIMMER
Adjusting the Bass & Treble
Using Direct Mode
CR-L5E.book Page 25 Monday, May 19, 2003 4:05 PM