I_/'ggl
mThere's no picture
Make sure that all video connecting plugs are pushed 15
ill all the way.
mThe remote controller doesn't work
Before operating this unit, be sure to press
RECEIVER.
If your TV is connected to the HDMI OUT, select 42
..... " ill the "HDMI Input" setup to watch
composite video, and component video sources.
Install new batteries. Don't mix different types of 4
batteries, or old and new batteries.
If the video source is connected to a composite video 17
input, your TV must be connected to the HDMI
OUT or the corresponding composite video output.
On your TV, make sure that the video input to which --
the AV receiver is connected is selected.
Make stare that the AV receiver is not subjected to
direct sunshine or inverter-type fluorescent lights.
Relocate if necessary.
Make stare you've selected the correct remote
controller anode.
11,65
NThere's no picture from a source connected to
an HDMI IN
Reliable operation with an HDMI-to-DVI adapter is 81
not guaranteed. In addition, video signals from a PC
are not guaranteed.
If the message "Resolution Error" appears on the --
AV receiver's display, this indicates that your TV
does not support the current video resolution and
you need to select another resolution on your DVD
player.
N The on-screen menus don't appear
On your TV, make sure that the video input to which --
the AV receiver is connected is selected.
Make stare you've entered the correct remote control 64
code.
N Can't control other components
[f it's an Onkyo component, make sure that the 1"-41
cable and analog audio cable are connected properly.
Connecting only an 1"-41cable won't be enough.
For a proper operation of the remote controller as a
cassette tape deck is connected to the TV/CD IN
jack, or as an RE Dock is connected to the TV/CD
IN, VCR/DVR IN or GAME IN jacks, you must set
the input display accordingly.
19
40
N The on screen display does not appear
Depending on the input signal, the on screen display 54
may not appear when the input signal from the
HDMI IN is output to a device connected to the
HDMI OUT.
N Reception is noisy, FM stereo reception is
noisy, or the FM STEREO indicator doesn't light
Relocate your antenna.
To control another manufacturer's component, point 64
the remote controller at that component.
To control an Onkyo component that's not
connected via RI, point the remote controller at the
component. Be sure to enter the appropriate remote
control code first.
65
Listen to the station in mono.
Passing cars and airplanes can cause interference.
27
If nothing improves the reception, install an outdoor --
antelnm.
Erl
69