Onkyo HT-R410 User Manual (English)

Other manuals for Onkyo HT-R410

Service Manual61 pages

Basic Operation Gude4 pages

Questions and Answers:

B
Brian MooreAug 19, 2025
Why is there no sound coming from my Onkyo Receiver?
- A
  Albert PerryAug 19, 2025
  If no sound is coming from your Onkyo Receiver, there could be several reasons: * The muting function might be activated, so deactivate it. * The connections to the AV receiver might not be properly connected, so check them. * The input selector might not be set correctly; set it to the correct input source. * Headphones might be connected; decrease the volume, then disconnect the headphones. * The input signal format might be set to 'PCM' or 'DTS'; set it to 'Auto'.
J
Jacob ArmstrongAug 21, 2025
What to do if my Onkyo Receiver doesn't switch on?
- D
  Dawn LawrenceAug 21, 2025
  If your Onkyo Receiver doesn't switch on: * Check the connection of the power cord. * There may be external noise interfering with the computer circuits of the AV receiver. Disconnect the power cord, then connect it again.
T
Tiffany AshleyAug 23, 2025
What to do if my Onkyo HT-R410 Receiver power shuts off immediately after powering on?
- Q
  qdicksonAug 25, 2025
  If your Onkyo Receiver shuts off immediately after powering on, the amplifier protection circuitry has been activated. Contact your Onkyo Service Center.
S
Shelley DeanAug 26, 2025
Why is there no sound or very little sound from the center speaker on my Onkyo Receiver?
- T
  Travis BruceAug 26, 2025
  If you're getting no sound or very little sound from the center speaker of your Onkyo Receiver, it could be due to a few reasons: * Check the speaker connections to ensure they are properly connected. * Note that no sound is reproduced from the center speaker when the listening mode is 'Stereo' or 'Orchestra'. * Adjust the volume level of the center speaker if it is set to minimum. * Ensure that the selected speaker configuration includes the center speaker.
F
Franklin PriceAug 28, 2025
What to do if the sound of the playback source is not heard on Onkyo Receiver?
- A
  Andrea WrightAug 28, 2025
  If you are not hearing the sound of the playback source on your Onkyo Receiver, make sure the appropriate input source is selected.
K
Kimberly NixonAug 30, 2025
What to do if the Onkyo HT-R410 buttons or remote controller buttons do not operate?
- D
  Daniel JacksonAug 30, 2025
  If the buttons on your Onkyo receiver or remote controller aren't working, it might be due to power supply fluctuations or other abnormalities like static electricity interrupting operation. Disconnect the power cord and then reconnect it.
C
cheryl27Sep 1, 2025
How to fix Onkyo Receiver when no picture appears on the TV screen?
- S
  suzanne40Sep 1, 2025
  If no picture appears on the TV screen when using your Onkyo Receiver, ensure that: * The TV is set to receive the input from the AV receiver. * The video cable is securely connected between the AV receiver and the TV. * If only the S video connection is made, also make a video connection and check both the TV's video input and the AV receiver's output signal.
K
kennethfordSep 3, 2025
Why do the remote controller buttons not operate my Onkyo AV receiver?
- V
  victoria03Sep 3, 2025
  If the buttons on the remote controller do not operate your Onkyo AV receiver, it could be due to several reasons: * Ensure you press the appropriate mode control button. * Insert new batteries if none are present. * Replace worn-out batteries with new ones. * Point the remote controller at the remote sensor of the AV receiver. * Operate the remote controller within 16 feet (5 m) of the AV receiver.
C
Christine WeaverSep 5, 2025
What causes hum or low-frequency noise in Onkyo HT-R410 Receiver?
- R
  Rachel BeltranSep 5, 2025
  Hum or low-frequency noise in your Onkyo Receiver can be caused by incorrect placement of the audio connection cables on the rear panel. Adjust the placement of the cables to reduce the hum.

Onkyo HT-R410 Specifications

Amplifier Section

Power Output Front L/R Speakers	100 Watts per channel min. RMS at 8 ohms 2 channel driven, 20-20, 000 Hz, 0.08% THD
Power Output Center Speaker	100 Watts min. RMS at 8 ohms, 20-20, 000 Hz, 0.08% THD
Power Output Surround L/R Speakers	100 Watts per channel min. RMS at 8 ohms 2 channel driven, 20-20, 000 Hz, 0.08% THD
Dynamic Power Output at 3 ohms	230 watts × 2
Dynamic Power Output at 4 ohms	170 watts × 2
Dynamic Power Output at 8 ohms	115 watts × 2

Input and Output Impedance

Digital Input Optical	0.5 Vp-p, 75 ohms
Digital Input Coaxial	0.5 Vp-p, 75 ohms
Line Input (CD, VIDEO 1, 2, 3, TAPE)	200 mV, 47 kohms
Multichannel Input (DVD FRONT L/C/R, SURR L/R)	200 mV, 47 kohms
Multichannel Input (SUBWOOFER)	36 mV, 47 kohms
Output Level Rec out (TAPE, VIDEO 1)	200 mV, 470 ohms
Output Level Pre out (SUBWOOFER)	1 V, 470 ohms

Tuner Section

FM Tuning Range	87.5-108.0 MHz (100 kHz steps)
FM Usable Sensitivity Mono	11.2 dBf, 1.0 µV (75 ohms, IHF)
FM Usable Sensitivity Stereo	17.2 dBf, 2.0 µV (75 ohms, IHF)
FM 50 dB Quieting Sensitivity Mono	17.2 dBf, 2.0 µV (75 ohms)
FM 50 dB Quieting Sensitivity Stereo	37.2 dBf, 20.0 µV (75 ohms)
FM Capture Ratio	2.0 dB
FM Image Rejection Ratio	40 dB
FM IF Rejection Ratio	90 dB
FM Signal-to-Noise Ratio Mono	76 dB, IHF
FM Signal-to-Noise Ratio Stereo	70 dB, IHF
FM Alternate Channel Attenuation	55 dB, IHF, ±400 kHz
FM Selectivity	50 dB (DIN)
FM AM Suppression Ratio	50 dB
FM Total Harmonic Distortion Mono	0.2%
FM Total Harmonic Distortion Stereo	0.3%
FM Frequency Response	30 Hz-15 kHz, ±1.0 dB
FM Stereo Separation at 1 kHz	45 dB
FM Stereo Separation at 100 Hz-10 kHz	30 dB
AM Tuning Range	530-1, 710 kHz (10 kHz steps)
AM Usable Sensitivity	30 µV
AM Image Rejection Ratio	40 dB
AM IF Rejection Ratio	40 dB
AM Signal-to-Noise Ratio	40 dB
AM Total Harmonic Distortion	0.7%

General Specifications

Power Supply	AC 120 V, 60 Hz
Power Consumption	4.7 A
Dimensions (W × H × D)	17-1/8” × 5-7/8” × 14-3/8”
Dimensions in mm (W × H × D)	435 × 150 × 365 mm
Weight	19.0 lbs., 8.6 kg

View in Manual

Summary

Important Safeguards

Precautions

Model-Specific Precautions

Safety guidelines and compliance information specific to U.S. and Canadian models, including FCC regulations.

Features

Supplied Accessories

Before Using the Unit

Initial Setup and Remote Operation

Instructions for inserting batteries into the remote and operating the unit and remote controller for the first time.

Index to Parts and Controls

Front Panel Overview

Identification and description of buttons, jacks, and indicators on the front panel of the AV receiver.

Display Indicators

Rear Panel Connections

Remote Controller Functions

Connecting Audio/Video Equipment

Speaker Setup and Connection

Standard Speaker Placement

Guidelines for positioning speakers for optimal surround sound reproduction in a typical room setup.

Using Speaker Labels

Instructions on how to use provided labels to correctly connect speaker cables to the receiver terminals.

Connecting Antennas

Indoor Antenna Installation

Guide to connecting and adjusting the supplied FM and AM indoor antennas for optimal reception.

Outdoor Antenna Connections

Remote Control (RI) Connections

RI System Operation Modes

Explanation of how RI connections enable system operation like power on/off, direct change, and power off functions.

Enjoying Music and Videos

Connecting Power and Selecting Sources

Steps to connect the power, turn on the receiver, and select an input source for playback.

Digital Sound Playback

Information on how digital audio signals are processed and indicated on the receiver's display.

Speaker Setup Configuration

Setting Speaker Channels and Crossover

How to configure the number of speaker channels and set the crossover frequency for optimal audio output.

Specifying Speaker Distances

Subwoofer and Volume Adjustment

Setting the Subwoofer Mode

Guide to selecting the appropriate subwoofer mode based on your speaker configuration and desired sound.

Adjusting Speaker Volume Balance

Procedure for adjusting the relative volume levels of individual speakers using a test tone.

Customizing Default Settings

TAPE to MD Source Switching

How to reassign the TAPE input to function as an MD input for source selection.

Configuring Digital Input Assignments

Instructions for changing the default digital input assignments for various sources like DVD and CD.

Listening to the Radio

Manual and Auto Tuning

Steps for manually tuning into radio stations and using the auto-tuning feature for FM reception.

Radio Station Presets

Presetting and Erasing Stations

How to store favorite radio stations for quick selection and how to remove stored presets.

Common Functions Across Sources

Speaker System A/B Control

Instructions for turning speaker systems A and B on or off, individually or simultaneously.

Muting and Headphone Listening

How to mute the audio output and listen privately using headphones connected to the receiver.

Display and Sleep Timer Functions

Changing Display Information

How to cycle through different display modes showing input source, volume, and listening mode.

Controlling Display Brightness

Method to adjust the brightness level of the AV receiver's front panel display.

Using the Sleep Timer

How to set the sleep timer to automatically turn off the receiver after a specified period.

Advanced Audio Adjustments

Temporary Volume Balance Adjustment

How to temporarily adjust the volume balance of each speaker while listening to audio.

Setting Input Signal Format

Guide to selecting the preferred audio input signal format (Auto, Multich, Analog) for each source.

Enjoying Multi-Channel Sources

Analog Multi-Channel Input

How to connect and enjoy analog 5.1-channel audio sources from components like DVD players.

Applying Audio Tone Adjustments

How to apply tone controls (Bass, Treble) and other audio enhancements for multi-channel sources.

Understanding Listening Modes

Surround Sound Formats

Explanation of Dolby Digital, DTS, and Dolby Pro Logic II surround sound technologies.

Original DSP and Stereo Modes

Overview of Onkyo's proprietary DSP modes and standard Stereo/Direct listening modes.

Selecting Listening Modes

Audio Adjustment Functions

Using Audio Adjust Functions

Guide to accessing and utilizing various audio adjustment features for fine-tuning sound.

Detailed Audio Adjustments

Recording Audio/Video Sources

Recording Watched/Listened Sources

Instructions for recording analog audio and video signals from the receiver to external components.

Recording Mixed Sources

How to record audio from one source and video from another to create custom recordings.

Using Remote Controller with Other AV Components

Entering Manufacturer Codes

Steps to program the remote controller to operate other AV components by entering manufacturer codes.

Remote Controller Operation Modes

Using the RC-518M Controller

Detailed instructions on how to use the RC-518M remote for controlling the HT-R410 and other components.

Component-Specific Remote Modes

CD/DVD Mode Operations

How to use the remote controller in CD/DVD mode to operate CD players and DVD players.

Tape Mode Operations

How to use the remote controller in Tape mode to operate cassette decks and recorders.

VCR Mode Operations

How to use the remote controller in VCR mode to operate VCRs and video recorders.

TV and Satellite Remote Modes

TV Mode Operations

How to use the remote controller in TV mode to operate televisions.

Cable/Satellite Mode Operations

How to use the remote controller in Cable/Satellite mode to operate cable boxes and satellite receivers.

Troubleshooting Guide

Amplifier Issues

Common problems with the AV receiver's amplifier section and their solutions.

Remote Controller Issues

Troubleshooting steps for common problems encountered with the remote controller.

Troubleshooting Other Components

Tuner Issues

Solutions for common problems related to tuner reception and sound quality.

Recording and Other Issues

Troubleshooting for recording problems, late night function, and multichannel audio output issues.

Technical Specifications

Amplifier and Tuner Specs

Detailed technical specifications for the amplifier and tuner sections of the AV receiver.

General and Remote Control Specs

General specifications, power requirements, dimensions, weight, and remote control details.

Related product manuals