25
DISPLAY
DIMMER
DIMMER
SLEEP
Changing the display
Press DISPLAY.
Each time you press DISPLAY, the screen changes as follows:
When an input source other than FM or AM is selected
FM/AM +
Listening mode
FM/AM frequency +
Preset no.
Input source +
Listening mode
(or Multich)
Input source +
volume
Program format*
Controlling the brightness of the display on the
AV Receiver
Press DIMMER.
Each press of the button changes the brightness as follows:
→ The display becomes less bright.
↓
The display is dimmed.
↓
The display becomes bright.
Using the sleep timer (remote controller only)
Press SLEEP.
“Sleep 90 min” appears in the multipurpose display for about
5 seconds, which means the AV Receiver will turn off and enter
standby mode in 90 minutes. Also the SLEEP indicator is lit in the
display while the sleep timer is on.
Press DISPLAY once to initiate the program format display.
Pressing the button again switches the display to the other display.
* When the input signal is digital audio
The program format is displayed. For example, the display
“Dolby D: 3/2.1” shows that the format is Dolby Digital with
5.1 discrete channels consisting of three front channels (front
left, front right, and center), two surround channels (surround
left and surround right), and the low frequency effect (LFE)
channel.
When the front channel number is 2, they are the front left and
front right; when it is 1, it is monaural. When the surround
channel number is 1, it is monaural; when it is 0, there is no
surround channel. When no LFE number is given there is no
LFE channel. Also, if there is no program format for the input
signal, nothing will be displayed.
When the input signal is linear PCM
The sampling frequency is displayed. For example, the display
“PCM fs: 44.1kHz” shows that the signal is PCM and that the
sampling frequency is 44.1 kHz.
When FM or AM is selected as the input source
SLEEP indicator
Each press of the button makes the remaining time shorter by
10 minutes.
Checking the remaining time
Press SLEEP while the sleep timer is On.
The remaining time is displayed.
If you press SLEEP while the remaining time is displayed, the
remaining time is reduced by 10 minutes.
Canceling the sleep timer
Press SLEEP repeatedly until the SLEEP indicator goes off.
Various functions common to all the sources
To Next Page
Loading...
Need help?
Amplifier Section
