EasyManua.ls Logo

Onkyo HT-R510 - User Manual

Onkyo HT-R510
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
AV Receiver
HT-R510
Instruction Manual
Thank you for purchasing the Onkyo AV Receiver.
Please read this manual thoroughly before making con-
nections and plugging in the unit.
Following the instructions in this manual will enable you
to obtain optimum performance and listening enjoyment
from your new AV Receiver.
Please retain this manual for future reference.
Contents
Introduction
Important Safeguards................................................2
Precautions................................................................3
Supplied Accessories................................................4
Features.....................................................................4
Before Using the HT-R510.......................................5
Controls & Connectors .............................................6
Connections
Connecting Your AV Components.........................10
Connecting -compatible AV Components..............19
Installing Your Speakers ........................................20
Connecting Antenna ...............................................22
Setup
Powering Up & Setting Up the HT-R510 ..............24
Configuring Speaker Set A.....................................25
Operation
Playing Your AV Components...............................28
Using the Tuner ......................................................30
Common Functions.................................................32
Using the Listening Modes.....................................34
Audio Adjust Functions..........................................37
Recording................................................................39
Remote Controller
Using the Remote Controller RC-518M with Your
Other AV Components........................................40
Appendix
Troubleshooting......................................................44
Specifications..........................................................47
En

Other manuals for Onkyo HT-R510

Questions and Answers

  • C
    Charles CowanAug 20, 2025
    Why is there no sound coming from my Onkyo HT-R510?
    • R
      Rebecca AlvarezAug 20, 2025
      There may be several reasons why you are not getting any sound from your Onkyo Receiver speakers. Ensure that the receiver is not muted. Check that all the connections are correct and the speaker cables are properly connected. Make sure the correct input source is selected and that headphones are not connected. Verify the input signal format is set to Auto, the volume is not at minimum, and the speakers are configured correctly. Also, check your connecting cables for any damage and replace them if necessary.
  • L
    Larry RayAug 22, 2025
    What to do if Onkyo Receiver remote controller buttons don't work?
    • J
      John RamosAug 22, 2025
      If the buttons on your Onkyo Receiver's remote controller are not working, make sure that the correct remote controller mode is selected. Install or replace the batteries, ensuring they are correctly installed. Point the remote controller at the receiver's remote sensor from a closer distance. Also, ensure that there isn't a strong light source interfering with the receiver's remote sensor. Relocate the receiver if necessary.
  • T
    Tony ParkerAug 25, 2025
    What to do if my Onkyo HT-R510 won't turn on?
    • M
      mbeasleyAug 25, 2025
      If your Onkyo HT-R510 won't turn on, first ensure the power cord is connected to a working wall outlet. If it still fails to turn on, it might be due to external interference. Turn off the receiver, wait five seconds, and try turning it on again. If that doesn't work, disconnect the power cord from the wall outlet, wait five seconds, reconnect it, and then try turning it on again.
  • J
    joshua51Aug 26, 2025
    What to do if my Onkyo HT-R510 buttons don't work?
    • C
      Christine GreenAug 26, 2025
      If the buttons on your Onkyo HT-R510 and remote controller aren't working, it might be due to power supply voltage fluctuations or static electricity. Turn off the receiver, wait five seconds, and try turning it on again. If that doesn't work, disconnect the power cord from the wall outlet, wait five seconds, reconnect it, and then try turning it on again.
  • K
    karitrujilloAug 27, 2025
    What to do if Onkyo HT-R510 shuts down immediately after being turned on?
    • M
      Micheal RoseAug 28, 2025
      If your Onkyo HT-R510 shuts down immediately after being turned on, the amp protection system has likely been activated. Please contact your Onkyo dealer.
  • C
    Christine PruittAug 29, 2025
    Why is my Onkyo subwoofer not working?
    • H
      hpattersonAug 29, 2025
      If your Onkyo subwoofer is not working or is very quiet, verify that the subwoofer mode is not set to OFF and is configured correctly. Also, check that the volume of the subwoofer is not set to minimum.
  • A
    angelachapmanAug 31, 2025
    Why is my Onkyo center speaker not working?
    • C
      choithomasAug 31, 2025
      If your Onkyo center speaker is not working or is very quiet, check the center speaker connections. The Stereo, Direct, or Orchestra listening mode may be selected, which do not use the center speaker. Also, verify that the volume of the center speaker is not set to minimum and that the currently selected speaker configuration uses the center speaker.
  • K
    Kimberly LewisSep 2, 2025
    Why are my Onkyo surround speakers not working?
    • C
      cody72Sep 2, 2025
      If your Onkyo surround speakers are not working, it may be because the surround speakers are not used with certain listening modes. Check the volume of the surround speakers to ensure it is not set to minimum. Also, verify that the currently selected speaker configuration uses the surround speakers.
  • D
    David CobbSep 4, 2025
    Why are only the front speakers working on my Onkyo HT-R510?
    • D
      Donna MurraySep 4, 2025
      If only the front speakers are working on your Onkyo receiver, the Stereo listening mode may be selected. In Stereo listening mode, only the front speakers and subwoofer are used.
  • M
    Mrs. Regina FrostSep 6, 2025
    Why is only the center speaker working on my Onkyo receiver?
    • R
      Ruben KnoxSep 6, 2025
      If only the center speaker is working on your Onkyo receiver, you may be listening to a mono sound source (e.g., TV or AM broadcast) and the PL II MOVIE or PL II MUSIC listening mode is selected. This concentrates the sound in the center speaker. Try selecting another listening mode.

Summary

Introduction

Important Safeguards

Essential safety guidelines to prevent hazards and ensure proper operation of the appliance.

Precautions

Important notes and warnings for safe handling, installation, and usage of the AV receiver.

Connections

Connecting Your AV Components

Guides on how to connect various audio and video sources to the AV receiver.

Installing Your Speakers

Instructions on how to connect and position speakers for optimal surround sound.

Connecting Antenna

Details on connecting FM and AM antennas for radio reception.

Setup

Powering Up & Setting Up the HT-R510

Steps for initial power-up, connecting to power, and basic system setup.

Configuring Speaker Set A

Guides on setting up speaker configurations, subwoofer modes, and distances.

Operation

Playing Your AV Components

How to select input sources and control playback of connected AV components.

Using the Tuner

Instructions for tuning into radio stations and managing presets.

Common Functions

Explains general functions like muting, speaker selection, and display information.

Using the Listening Modes

Details on selecting different sound modes for various types of audio sources.

Audio Adjust Functions

How to fine-tune audio settings like bass, treble, and surround effects.

Recording

Guide on how to record audio and video from different sources.

Remote Controller

Using the Remote Controller RC-518 M with Your Other AV Components

Instructions for using the remote to control other AV components and enter manufacturer codes.

Appendix

Troubleshooting

Common problems and their solutions for the AV receiver.

Specifications

Technical details and performance characteristics of the HT-R510.

Onkyo HT-R510 Specifications

General IconGeneral
Channels5.1
Frequency Response10 Hz - 100 kHz
Total Harmonic Distortion0.08%
Tuning RangeFM/AM
Speaker Load Impedance6-16 ohms
Input Sensitivity and Impedance200 mV/47 kΩ (Line)
Surround SoundDolby Digital, DTS
Inputs2 x Optical, 1 x Coaxial, 4 x Analog
Outputs1 x HDMI, 1 x Subwoofer
Video ConnectionsHDMI, Composite
Signal-to-Noise Ratio100 dB
Dimensions (W x H x D)435 x 150 x 379 mm

Related product manuals