To Next PageTo Next Page
Need help?Do you have a question about the Onkyo HT-R530 and is the answer not in the manual?
General| Channels | 7.1 |
|---|---|
| Frequency Response | 10 Hz - 100 kHz |
| Total Harmonic Distortion (THD) | 0.08% |
| Audio Decoding | Dolby Digital, DTS |
| Signal-To-Noise Ratio | 106 dB |
| Input Sensitivity | 200 mV |
| Audio D/A Converter | 192kHz / 24-bit |
| Built-in Decoders | Dolby Digital, DTS |
| Tuner Bands | AM/FM |
| Preset Station Qty | 40 |
| Connector Type | RCA, HDMI |
| Dimensions | 435 x 168 x 329 mm |
| Weight | 9.5 kg |
| Response Bandwidth | 5 Hz - 100 kHz |
| Input Impedance | 47 kOhm |
| Surround Sound Effects | Theater-Dimensional |
| Sound Effects | Theater-Dimensional |
| Tuning Range | AM: 530 kHz - 1710 kHz, FM: 87.5 MHz - 108.0 MHz |
| Audio Inputs/Outputs | 2 x Optical, 2 x Coaxial |
| Video Inputs/Outputs | 3 x Component, 5 x Composite |
| Power Output | 130W per channel (6 ohms, 1 kHz, 1% THD, 1 channel driven) |
Technical specifications for the amplifier section, including power output and THD.
Procedure for replacing fuses, emphasizing using the correct type for protection.
Step-by-step guide to perform the DC voltage detection for speaker protection.
Step-by-step guide for current detection in speaker protection.
Steps to check the output sensor functionality, including volume and relay status.
Steps to check the thermal sensor by verifying temperature display accuracy.
Steps to enter the DSP debug mode by pressing specific buttons while powering on.
Printed circuit board layout for the Display PC Board (U01), showing component placement on Side A.
Printed circuit board layout for the DSP PC Board (U02), showing component placement on Side B.
Printed circuit board layout for the DSP PC Board (U02), showing component placement on Side A.
Printed circuit board layout for the Switch PC Board (U03), showing both Side A and Side B.
Printed circuit board layout for the Headphone Jack PC Board (U04), showing both Side A and Side B.
Printed circuit board layout for the Amplifier PC Board (U05), showing the component side.
Printed circuit board layout for the Amplifier PC Board (U05), showing the soldering side.
Printed circuit board layout for the Sec. Terminal-2 PC Board (U06), showing the component side.
Printed circuit board layout for the SBR Amplifier PC Board (U07), showing the component side.
Printed circuit board layout for the Thermal Sensor PC Board (U08), showing the component side.
Printed circuit board layout for the Power Supply-1 PC Board (U11), showing the component side.
Printed circuit board layout for the Power Supply-2 PC Board (U13), showing the component side.
Printed circuit board layout for the Sec. Terminal PC Board (U14), showing the component side.
