Advanced
Setup-Continued
Thefollowing table shows the display indicators for each
supported digital signal format.
Format
Display
Dolby Digital
C[]
D
DTS
~
PCM
PCM
Normally, the
AV
receiverdetects the signal format auto-
matically. However,
if
you experience either
of
the fol-
lowing issues when playing
PCM
or
DTS material, you
can manually set the signal format to
PCM
or
DTS:
•
If
the beginnings
of
tracks from a
PCM
source are
cut
off, try setting the format to PCM.
•
If
noise is produced whenfast forwarding
or
reversing
a DTS CD, try setting the format to DTS.
o
DIGITAL INPUT
Press and
hold
the
AV
receiver's [DIGITAL
INPUT]
button
for
about
3 seconds.
While
"Auto"
is
displayed (about 3 sec-
onds),
press
the
[DIGITAL INPUT]
button
again
to
select: PCM, DTS,
or
Auto.
DTS
or
PCM:
The
DTS
or
PCM
indicator,
depending
on
which format you have set, flashes,
and only signals in that format are output. Digital
signals in other formats are ignored.
Auto
(default):
The
format is detected automati-
cally.
If
no digital input signal is present, the cor-
responding analog input is used instead.
When using progressive scanning
on
your DVD player,
you may find that the picture and sound are out
of
sync.
With this setting, you can correct this by delaying the
audio signals. You can set it to 0, 20,
or
40
milliseconds.
l[iiiiiii~~-
RECEIVER
Press
the
[RECEIVER] REMOTE
MODE button.
Press and hold,
for
more
than 4
seconds, the
input
selector but-
ton
for
the
input
source
that you
want
to
correct.
This can
be
the [DVD], [VIDEO I],
[VIDEO 2],
or
[VIDEO 3] input
source.
Use
the
Left and Right
[~]I[~]
buttons
to
set
the
delay
to
0,
20,
or
40
milliseconds.
The previous display reappears
if
you
don't
do
anything for 5 minutes.
Note:
• This setting is not available when the Direct listening
mode
is
used with an analog input signal.
57
To Next Page
Loading...
Need help?
General
