56
Advanced
Setup-Continued
Crossover Frequency
This setting only applies to the speakers that you speci-
fied
as
Small in the "Speaker Configuration" on page 55.
To get the best bass performance from your speaker sys-
tem, you need to set the crossover frequency according
to the size and frequency response
of
your speakers.
7
'.'
.•.
~.
,Use the Down
[T]
button
to
~
;
",'..
select "Crossover," and then use
, ,
'0
the Left and Right
[~]I[~]
but-
.•..•....
~.;
........•.•....•.
' '
..
tons
to
select a crossover fre-
~.~;
.
.•...
quency.
t.;i
F
'.
Use the diameter
of
the smallest
••
,,': 1 speaker in your system when choosing
the crossover frequency.
Speaker cone Crossover
diameter
frequency
Over 8 in.
40/50/60Hz·
(20
em)
6-1/2 to 8 in.
80Hz
(16-20
em)
5-1/4 to 6-1/2 in.
100Hz
(13-16
em)
3-1/2 to 5-1/4 in.
120Hz (default)
(9-13
em)
Under 3-1/2 in.
150/200Hz·
(9
em)
*Choose the setting suitable for the speaker.
Continue with step 8
of
the "Double
°'''1 Bass" setting below.
;:~;'
it
Notes:
• For a more accurate setting, look up the frequency
response in the manuals supplied with your speakers
and set accordingly.
• Choose a higher crossover frequency
if
you want more
sound from your subwoofer.
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left and right
channels to the subwoofer. This function can be set only
if
the Subwoofer setting (step 3) is set to Yes, and the
Front setting (step 4) is set to Large in the Speaker Con-
figuration on page 55.
\~
Use the Down
[T]
button
to
.'
select "Double Bass," and then
• use the Lett and Right
[~]I[~]
buttons
to
select:
On:
Double Bass function on.
Bass from the front left and
right channels is also fed
to
the subwoofer (default).
Off: Double Bass function off.
Press the [SETUP] button.
Setup closes.
When you want to go back up one
menu level to "SP Config," press the
[RETURN] button.
To Next Page
Loading...
Need help?
General
