41
Turning On the AV Receiver
ON/STANDBY
STANDBY
SPEAKERS
TONE
MOVIE/TV MUSIC GAME
DISPLAY RT/PTY/TP MEMORY
CLEAR
DIGITAL INPUT TUNING MODE
BA
PHONES
MULTI CH
DOCK
DVD VCR/DVR CBL/SAT AUX TAPE TUNER CD
SETUP
SETUP MIC
VIDEO
L AUDIO R
AUX INPUT
ENTER
RETURN
TUNING PRESET
MASTER VOLUME
AV RE CEIVER
HT-R560
ON/STANDBY
RECEIVER
ON/STANDBY
STANDBY indicator
Turning On and Standby
On the AV receiver, press the [ON/STANDBY] button.
On the remote controller, press the [RECEIVER] REMOTE MODE button,
followed by the [ON/STANDBY] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
To turn the AV receiver off, press the [ON/STANDBY] button, or press the remote
controller’s [ON/STANDBY] button. The AV receiver will enter Standby mode. To
prevent any loud surprises the next time you turn on the AV receiver, turn down the
volume before you turn it off.
ON/STANDBY
Remote
controller
AV receiver
or
Up and Running in a Few Easy Steps
To get your system up and running with the minimum of fuss, here’s a few pointers to help you configure the AV
receiver before you use it for the very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See “Automatic Speaker Setup (Audyssey 2EQ)” on page 42.
■ Did you connect a component to an HDMI input,
component video input, or digital audio input?
If you did, see “HDMI Input Setup” on page 44, “Component Video
Input Setup” on page 45, or “Digital Input Setup” on page 46 respec-
tively.
■ Did you connect an Onkyo MD recorder or CD recorder?
If you did, see “Changing the Input Display” on page 46.
OPTICAL
COAXIAL
Y
P
B
PR
HDMI
OUT IN
TAPE
MD recorder, CD recorder
HT-S5100En.book Page 41 Monday, May 19, 2008 1:47 PM
To Next Page
Loading...
Need help?
General
