EasyManuals Logo

Onkyo HT-S5910 User Manual

Onkyo HT-S5910
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
103
Front Panel Rear Panel Remote
Contents
Connections
Playback
Setup
ZONE B function
Cannot ZONE B-output the audio of externally connected AV components
To output audio to ZONE B, set the audio output destination to "ZONE A+B" or "ZONE B". ( p55)
Remote Controller
Make sure that the batteries are inserted with the correct polarity.
Insert new batteries. Do not mix different types of batteries, or old and new batteries.
Make sure that the sensor of the main unit is not subjected to direct sunlight or inverter-type uorescent lights. Relocate it if necessary.
If the main unit is installed in a rack or cabinet with colored-glass doors, or if the doors are closed, the remote controller may not work normally.
Display
The display does not light up
When the Dimmer function is working, the display may go dim. Press the DIMMER button, and change the brightness level of the display. ( p9)
Others
Strange noise can be heard from the unit
If you have connected another device to the same outlet as this unit, strange noise may occur under the inuence of the device. If the symptom is
remedied by removing the power plug of the other device from the outlet, use different outlets for this unit and the device.
The message "Noise Error" appears during AccuEQ Room Calibration
This can be caused by a malfunction in your speaker unit. Check the speaker output, etc.
The measurement results of AccuEQ Room Calibration show different distances to the speakers from
the actual ones
Depending on the speakers you are using, some errors may occur in the measurement results. If this is the case, make the settings in
"2. Speaker" - "Distance" in the Setup menu.
( p84)
The measurement results of AccuEQ Room Calibration show that the volume level of the subwoofer
has been corrected to the lower limit
The volume level correction of the subwoofer may not have been completed. Lower the volume of the subwoofer before AccuEQ Room
Calibration measurement.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo HT-S5910 and is the answer not in the manual?

Onkyo HT-S5910 Specifications

General IconGeneral
Receiver typeSurround
Frequency range10 - 100000 Hz
Input sensitivity200 mV
4Ω speaker supportNo
Audio output channels5.1.2 channels
Total Harmonic Distortion (THD)0.08 %
Dynamic power per channel (3 Ohm)160 W
Power output per channel (20-20KHz@8 Ohm)115 W
DisplayLCD
Product colorBlack
Audio decodersDolby Atmos
Damping factor60
Amplifier output power925 W
HDMI in4
Composite video in3
Digital audio coaxial in1
Digital audio optical in2
Ethernet LAN (RJ-45) ports0
Audio (L/R) out7
Connectivity technologyWired
Speakers connectivity typeClamp terminals
Supported radio bandsAM, FM
AC input voltage120 V
AC input frequency60 Hz
Weight and Dimensions IconWeight and Dimensions
Depth328 mm
Width453 mm
Height160 mm
Weight7800 g

Related product manuals