Onkyo HT-S5910 User Manual

45
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Connecting an AV Component in a Separate Room (ZONE B Connection)
Connecting a Pre-main Amplier (ZONE B)
While performing playback in the main room (ZONE A), you can enjoy 2-ch audio
of the same source in the separate room (ZONE B) at the same time. Use an
analog cable to connect the ZONE B PRE/LINE OUT jack of this unit and the
LINE IN jack of the pre-main amplier or power amplier in the separate room.
Setup
When connecting the power amplier, set "Zone B Output Level" to "Variable"
for "Speaker Setup" in the Initial Setup section (
p94). When setting "Zone
B Output Level" from the Setup menu, press on the remote controller, and set
"2. Speaker" - "Conguration" - "Zone B Output Level" ( p82) to "Variable". If
it is not set, a large volume is output and the power amplier, speakers, etc. may
be damaged.
a
LINE
IN
Premain Amp.
a Analog audio cable

Onkyo HT-S5910 Specifications

General

Receiver type	Surround
Frequency range	10 - 100000 Hz
Input sensitivity	200 mV
4Ω speaker support	No
Audio output channels	5.1.2 channels
Total Harmonic Distortion (THD)	0.08 %
Dynamic power per channel (3 Ohm)	160 W
Power output per channel (20-20KHz@8 Ohm)	115 W
Display	LCD
Product color	Black
Audio decoders	Dolby Atmos
Damping factor	60
Amplifier output power	925 W
HDMI in	4
Composite video in	3
Digital audio coaxial in	1
Digital audio optical in	2
Ethernet LAN (RJ-45) ports	0
Audio (L/R) out	7
Connectivity technology	Wired
Speakers connectivity type	Clamp terminals
Supported radio bands	AM, FM
AC input voltage	120 V
AC input frequency	60 Hz

Weight and Dimensions

Depth	328 mm
Width	453 mm
Height	160 mm
Weight	7800 g