Onkyo HT-S7100

47
Playing Your AV Components
Basic AV Receiver Operation
ON/STANDBY
ZONE 2
ZONE 2 LEVEL
TONE
MOVIE/TV MUSIC GAME DISPLAY RT/PTY/TP MEMORY
CLEAR
DIGITAL INPUT TUNING MODE OFF
PHONES
MULTI CH DVD VCR/DVR CBL/SAT GAME/TV AUX TAPE TUNER CD
SETUP
SETUP MIC VIDEO
L AUDIO R
AUX INPUT
ENTER RETURN
TUNING PRESET
MASTER VOLUME
AV RECEIVER TX-SR606
STANDBY
ZONE 2
PURE AUDIO
3
1
3
1
1
Use the AV receiver’s input selector buttons to select an input source.
To select an input source with the remote controller, press its INPUT
SELECTOR buttons.
To listen to a DVD player connected to the multichannel DVD input (page 25), press
the AV receiver’s [MULTI CH] button. The MULTI CH indicator will appear on the
display.
Note:
• While the multichannel DVD input is selected, the Speaker Configuration settings on
page 72 are ignored, and signals from the multichannel input are fed to the speakers
as they are.
2
Start playback on the source component.
To watch a DVD or other video source, on your TV, select the video input that’s con-
nected to the AV receiver’s COMPONENT VIDEO OUT, HDMI OUT, or MONITOR
OUT.
On some DVD players, you may need to change the digital or HDMI audio output
settings.
3
To adjust the volume, use the MASTER VOLUME control or the remote
controller’s [VOL] button.
Since the AV receiver is designed for home theaters, it has a wide volume range for
precise adjustment. The volume can be set to Min, 1 through 79, or Max.
4
Select a listening mode and enjoy!
See “Using the Listening Modes” on page 57.
DVD VCR/DVR CBL/SAT
GAME/TV AUX TAPE
TUNER
CD
Remote
controller
AV receiver
Remote
controller
AV receiver
MASTER VOLUME
HT-S7100En.book Page 47 Friday, July 11, 2008 10:36 AM