Onkyo NC-500 Service Manual

NC-500
SERVICE MANUAL
SERVICE MANUAL
Audio Network Receiver
Silver model only
MODEL NC-500
120V AC, 60HzTUDD
Ref. No. 3751
112002
AUDIO NETWORK RECEIVER
NC
-
500
STANDBY / ON
VOLUME
AUDIO
INPUT
DISPLAY
PHONES
SELECT
SETUP
STANDBY
Restoring the factory default settings:
To reset all the stored settings to the factory
default conditions, while the power to the NC-500
is on, press and hold down the STOP button on
the unit, and press STANDBY/ON button.
SAFETY-RELATED COMPONENT
WARNING!!
COMPONENTS IDENTIFIED BY MARK ON THE
SCHEMATIC DIAGRAM AND IN THE PARTS LIST ARE
CRITICAL FOR RISK OF FIRE AND ELECTRIC SHOCK.
REPLACE THESE COMPONENTS WITH ONKYO
PARTS WHOSE PART NUMBERS APPEAR AS SHOWN
IN THIS MANUAL.
MAKE LEAKAGE-CURRENT OR RESISTANCE
MEASUREMENTS TO DETERMINE THAT EXPOSED
PARTS ARE ACCEPTABLY INSULATED FROM THE
SUPPLY CIRCUIT BEFORE RETURNING THE
APPLIANCE TO THE CUSTOMER.

Onkyo NC-500 Specifications

General

Audio formats	MP3, WMA, AAC, WAV, FLAC, ALAC
Network	Ethernet, Wi-Fi
Streaming services	Spotify, TIDAL, Deezer, TuneIn
Amplifier power	30 W + 30 W (4 Ohms, 1 kHz, 0.7% THD, 2 Channels Driven, IEC)
Power Output	30 W + 30 W (4 Ohms, 1 kHz, 0.7% THD, 2 Channels Driven, IEC)
Frequency response	10 Hz–100 kHz/+1 dB, -3 dB (Direct Mode)
Frequency Response (Direct Mode)	10 Hz–100 kHz/+1 dB, -3 dB
Inputs	USB, Analog, Optical
Outputs	Speaker terminals, Headphone
Audio Decoders	Dolby Atmos, DTS:X