69
En
■ Proxy URL
To use a Web proxy, enter its URL here.
■ Proxy Port
If you’re using a Web proxy, enter a proxy port number
here.
■ Network Control
` Enable
` Disable
This setting enables or disables control over the network.
Note
• When set to “Enable”, the NET indicator is dimly-lit and the
power consumption slightly increases in standby mode.
■ Control Port
` “49152” to “65535”
This is the network port used for control over the network.
Note
•When the “Network Control” setting is set to “Disable”, this
setting is cannot be selected.
Firmware Update
See “Firmware Update” for the update procedure
(➔ page 92).
Note
• Perform the firmware update only when such an announcement
is posted on the Onkyo web site. Visit the Onkyo web site for the
latest information.
• It takes maximum 60 minutes to complete the firmware update.
■ Version
Displays the current version of the firmware.
■ Receiver
` via NET:
Performs the firmware update via Internet. Check
the network connection before updating.
` via USB:
Performs the firmware update from a USB device.
These settings allow you to update the AV controller’s
firmware. Do not shutdown the power of the AV
controller while updating.
■ Universal Port
` via NET:
Performs the firmware update via Internet. Check
the network connection before updating.
` via USB:
Performs the firmware update from a USB device.
These settings allow you to update Onkyo dock’s
firmware. Do not shutdown the power of the AV
controller while updating.
Note
• This update shall not be performed when no dock is connected
to the UNIVERSAL PORT jack.
Main menu Remote Controller Setup
Remote Mode Setup
See “Looking up for Remote Control Code”
(➔ page 80).
Activities Setup
Via onscreen menu, you can specify what actions will be
taken by the Easy macro command in the Easy macro
mode (➔ page 46).
First, select the ACTIVITIES (MY MOVIE, MY TV, or
MY MUSIC) that you want to configure.
■ Source
` BD/DVD, VCR/DVR, CBL/SAT, GAME, PC,
AUX, TUNER, TV/CD, PHONO, PORT, NET,
USB
With this setting, you can choose the target input source of
the Easy macro.
■ TV Power On
` Enable
` Disable
With this setting, you can specify whether or not to turn on
your TV.
■ Source Power On
` Enable
` Disable
With this setting, you can specify whether or not to turn on
the source component.
■ Receiver Power On
` Enable
` Disable
With this setting, you can specify whether or not to turn on
the AV controller.
■ Receiver Source Change
` Enable
` Disable
With this setting, you can specify whether or not to change
the input source.
■ Source Play
` Enable
` Disable
With this setting, you can specify whether or not to start
playback.
Remote Controller Setup
To Next Page
Loading...
Need help?
General
Weight and Dimensions
