91
En
■ If the picture on your TV/monitor connected to
the HDMI output(s) is unstable, try switching
the DeepColor function off
To turn off the DeepColor function, simultaneously
press the CBL/SAT and 8ON/STANDBY buttons on
the AV controller. While holding down CBL/SAT,
press 8ON/STANDBY repeatedly until “Off” appears
on the display and then release both buttons. To
reactivate the DeepColor function, repeat the above
process until “On” appears on the display and release
the buttons.
The AV controller can upconvert component video, S-
Video, and composite video sources for display on a TV
connected to the HDMI output(s). However, if the picture
quality of the source is poor, upconversion may make the
picture worse or disappear altogether.
In this case, try the following:
Tip
• To by-pass the upconversion, set the “Picture Mode” setting to
“Direct” (➔ page 61).
The AV controller contains a microcomputer for signal
processing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least five seconds, and then plug it
back in.
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
the unit’s malfunction. Before you record important
data, make sure that the material will be recorded
correctly.
Before disconnecting the power cord from the wall
outlet, set the AV controller to standby.
Important Note Regarding Video Playback
1
If the video source is connected to a component
video input, connect your TV to the
COMPONENT VIDEO MONITOR OUT.
If the video source is connected to an S-Video input,
connect your TV to a MONITOR OUT S.
If the video source is connected to a composite video
input, connect your TV to the MONITOR OUT V.
2
On the main menu, select “Input/Output Assign”
and then “Component Video Input” (➔ page 51).
If the video source is connected to COMPONENT
VIDEO IN 1, select the relevant input selector, and
assign it to “IN1”.
If the video source is connected to COMPONENT
VIDEO IN 2, select the relevant input selector, and
assign it to “IN2”.
If the video source is connected to COMPONENT
VIDEO IN 3, select the relevant input selector, and
assign it to “IN3”.
If the video source is connected to an S-Video input
or composite video input, select the relevant input
selector, and assign it to “-----”.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
