15
If your other components are made by ONKYO and those components are equipped with
connectors, you can control the -connected components with the supplied remote control-
ler.
Before connecting
• The unit must be connected in the system hookups for control operations.
• Each component has two connectors. There is no difference between these connectors.
• The components may be connected in any order.
• The hookups on the previous page are necessary independently of the system hookups.
The illustration below is an example of a hookup.
Connections
Note:
Select “CD” as the input display when you connect a CD player to the R-801A’s CD/DVD con-
nector, and select “DVD” when you connect a DVD player. If you select the wrong input, the
system will not operate even if the connection is correct.
Toggling between “CD” and “DVD” for the input display
To toggle between “CD” or “DVD” for the input display, make sure that the
display indicates “CD” or “DVD,” then press and hold down the CD/DVD but-
ton on the remote controller for two seconds or more.
Connecting the remote control cables
remote control cable (supplied with
every ONKYO component that has
connectors except for the amplifier and
receiver)
This unit
MD recorder
Audio
(R-801A)
• This is not an example of stacking the components. For the example, refer to page 9.
CD player
CD recorder
CD/ DVD
To Next Page
Loading...
Need help?
General
