En-
13
Connecting Your Components
—Continued
If you connect the T-4030 to another Onkyo -capable
component with the supplied cable and audio cable,
you can use the following system functions. cables
are special cables solely for use with Onkyo products.
Auto Power On
When you turn on the T-4030, your Onkyo amplifier will
turn on automatically. (The amplifier’s POWER switch
must be set to ON for this to work.)
Direct Change
When you select a radio preset or change the band (FM,
DAB), your Onkyo amplifier will automatically select
the T-4030 as the input source.
Remote Control Operation
You can control the T-4030 by using your Onkyo
amplifier’s remote controller. See the amplifier’s
instruction manual for details.
With (Remote Interactive), you can control your
-capable Onkyo CD player, T-4030, and so on with
your amp’s remote controller.
Notes:
• Push each plug in all the way to make a good
connection.
• Use only dedicated cables for connections.
cables are supplied with Onkyo tuners and players
(DVD, CD, etc.).
• Some components, including the T-4030, have two
jacks. They’re both the same, so use either one.
• jacks should be connected only to Onkyo
components.
• Connecting them to another manufacturer’s
component may cause a malfunction.
• Some components may not support all functions.
See the manuals supplied with your other Onkyo
components for more information.
Connect the power cord to a suitable wall outlet.
Note:
• Before connecting the power cord, connect all of
other components.
1
Press the [Í ON/STANDBY] button.
Alternatively, press the remote controller’s
[Í] button.
The tuner comes on, and the display lights up.
To turn the tuner off, press the [
Í
ON/STANDBY]
button, or press the remote controller’s [
Í
] button. The
tuner will enter Standby mode.
Connecting Onkyo Components
T-4030
Onkyo amplifier
Onkyo CD player
jack
jack
Connecting the Power Cord
Turning On and Standby
SN29401267A_T-4030_En_20161004-2.book 13 ページ ２０１６年１０月４日 火曜日 午後６時１０分
To Next Page
Loading...
