Onkyo TX-906 - Page 15

NOTES:
@ The source selected with the input selector will be output
at REC OUT of TAPE-1, 2, VIDEO-2 in the Simul Source
mode.
When FM or AM has been selected on the tuner as described
in step (2) with the input selector being other than TUNER,
the display will show the tuner indication for five seconds,
between the scanning of the CLASSIFIED SCAN programs
and the preset station of the tuner can be selected during
this period. When the input selecter is TUNER, the FM/AM
bands are not switched, if the FM or AM band is selected
on the TUNER, by the REC OUT button.
@ Recording and dubbing to a tape deck connected to TAPE-2
< oO Press the input selector button of the source to be recorded.
®
Source
required
(Other
than
TAPE-2)
(2) Put a blank tape in TAPE-2.
(3) Start playing back the device selected in step Q), and start
recording on TAPE-2.
@ When the TAPE-2 MONITOR button is in the OFF position,
the source signals can be monitored through the speakers
or the headphones. !f tape deck 2 has three heads, the
Just-recorded signals can be monitored (when the TAPE-2
MONITOR button ts in the ON position). Refer to the tape
deck instruction manuals for more details.
@ Set the recording level using the controls on the tape deck
Source
selected
in
Tape
Deck
used
for
recording.
Also,
during
recording
and
dubbing
@)
Insert
blank
Operations.
never
change
the
positions
of
any
controls
(3)
Start
playback
Tape
(bass,
treble,
etc.)
on
this
unit.
(3) Start recording
a
ee
®@ Using the Graphic Equalizer
1) Connect the graphic equalizer to the TAPE-2 jacks on the
rear panel.
(2) If a second tape deck is used, connect it to the tape jacks
on the graphic equalizer.
(3) Press the TAPE-2 MONITOR button.
(4) Foilow the graphic equalizer operating instructions.
6) To record an equalized signal, use tape deck 2 (connected
to the equalizer) for recording.
M@
Video
Disc
Player
(or
Video
Camcorder)
to
VCR
re-
Video
disc
programs
can
be
recorded
onto
a
VCR
(VIDEO-2)
cording
Load
a
disc
in
the
video
disc
player,
and
a
blank
tape
in
the
VCR (VIDEO-2)
Press the VIDEO-1 input selector button.
Begin playback of the video disc player and recording of the
VCR.
@ Refer to the video disc player, video camcorder or VCR
instruction manuals for additional information.
S
@ VIDEO-1
NOTES:
@ When REC OUT ts set to VIDEO-2, you can not record the
sound and video of the VCR (VIDEO-2). Change REC OUT
to [SOURCE] ( [VIDEO-11).
If you want to mix an other sound SOURCE onto the video
oo ooo
eodSsSseqo ro
oles PITT Tes O © AO
Video Disc Player or
Video Camcorder
(VIDEO-1)
1) Insert Video
disc
(3 Start playback
signal from VIDEQO-1. choose the SOURCE using the REC
VCR (VIDEO-2) OUT button.
The source selected with the input selector will be output
(1)
Insert
blank
at
REC
OUT
of
VIDEO-2
in
the
simul
source
mode.
tape
(2) Start recording