Onkyo TX-NR717 - Turning On & Basic Operations; Receiver Power and Initial Setup

To Next Page

To Previous Page

TX-NR717/818/ DTR-40.4/50.4

OPERATION CHECK-5

2.TEST MODE(2/4)

2-2. TEST MODE FOR OPERATION(Continue)

e. Test mode is as follows.

TEST

1-00

1-01

2-00

2-01

2-02

2-03

2-04

2-05

2-06

2-07

2-08

2-09

2-10

2-11

2-12

2-13

2-14

2-15

2-16

2-17

2-18

2-19

2-20

2-21

2-22

2-23

2-24

2-25

2-26

2-28

3-00

3-01

3-02

3-03

3-04

3-05

3-06

3-07

3-08

3-09

3-10

3-11

3-12

3-13

3-14

3-15

3-16

3-17

3-18

Analog Input

/Rec Sel

(Zone2/Zone3)

BD/Source

CBL/Source

STB/Source

GAME/Source

AUX/Source

PC/Source

TV/Source

AUX/Source

MIC

PHONO/Source

BD/Source

BD/Source(Source)

BD/Source

FM/Source

TV(BD/GAME)

USB(Front)/(Source)

USB(Rear)/(Source)

NET/(Source)

Lstn Mode/

Input Format

ADC DSP 8ch Thru.

Stereo(Direct)

ADC DSP 10ch Thru.

Automatic

DIR DSP 10ch Thru

Automatic

DIR DSP 10ch Thru

ADC DSP 10ch Thru.

Direct

Bi AMP

Whole House Mode

ADC DSP 10ch Thru.

Stereo(Direct)

VIDEO Input

(Zone2)

BD/DVD

CBL/SAT

STB/DVR

GAME

AUX

Last

AUX

BD/DVD

Last

Last(BD)

Last

Compo-

nent V

IN1

IN2

IN1

HDMI

IN1

IN2

IN3

IN4

IN1

12V

Trigger

Zone2/A

Zone3/B

Z2/Z3

Digital Input

/Output

OPT1

COAX1

OPT1

COAX1

OPT2

FRONT OPT

USB(Front)

USB(Rear)

NET

Config.

Y/L/L/L/L

Master Vol.

/Zone2 Vol.

Max (+18dB)

Min (-82dB)

Max (+18dB)

82 (0dB)

Max (+18dB)

82 (0dB)

70 (-12dB)

Min (-82dB)

82 (0dB)

Max (+18dB)

82 (0dB)

Max (+18dB)

82 (0dB)

Max (+18dB)

62 (-20dB)

82 (0dB)

84 (+2dB)

Max (+18)/Max(+18)

0dB/0dB

Min/Min

-20dB/-20dB

0dB/0dB

-20dB/-20dB

Speaker

Relay

F/C/S/SB

F/C/S/FW

F/C/S/FH

F/C/S/SB

F/C/S/SB/FW

F/C/S/SB/FH

C/S/SB

F/C/S/SB

F/C/S/SB/FH

F/C/S/SB

F/C/S/FH

F/C/S/SB

F/C

F/Z2/Z3

etc.

SW=NO

SW:MUTE

SPRLF OFF

MICMUTE ON

Bi AMP

Whole House Mode

EXT AMP(SB)

Diffential signal mode

Z2/Z3 MUTE ON

Z2 BASS MAX

Z2 BASS MIN

Z2 TREBLE MAX

Z2 TREBLE MIN

Output Level / Distortion

SN Ratio

Freq. Resp.

Separation

Output Level / Distortion

Net connection

*1 PROTECT

Preout=SB

EXT AMP OUT=SB

Z2/Z3 Powered

WAV,44.1kHz,16bit,1kHz,0dBfs,

WAV,44.1kHz,16bit,-∞dBfs,

WAV,44.1kHz,16bit,20Hz,0dBfs,

WAV,44.1kHz,16bit,20kHz,0dBfs,

WAV,44.1kHz,16bit,1kHz,0dBfs,Lch

WAV,44.1kHz,16bit,1kHz,0dBfs,Rch

WAV,48kHz,16bit,1kHz,0dBfs,

Display IP address

In all test modes, it is not concerned with detection of VOLH but SEC1H are made "H" fixation. (Except TEST 2-25,4-43.)

*1 : All SP-RELAYs are turned ON only at the time of this STEP.

Moreover, whether make RELAY restoration time at the time of protection operation into 1 second, and PROTECT input "H" is detected

how many times or it continues 1 second or more, RELAY is not held at OFF or POWER OFF is not carried out, either.

When "H" is 1 seconds or more to PROTECT input and it is set to "L", RELAY is turned ON again.

Moreover, not any MUTE is outputted at the time of this STEP.

NOTE-1: For inspection procedure of NET, TEST 3-11 should be measured first. (for prevention of the malfunction)

NOTE-2: TEST of NET/USB can't do immediately after the start-up. It should be measure after other TEST.

Main Page

Onkyo TX-NR717 - Turning On & Basic Operations; Receiver Power and Initial Setup

Table of Contents

Other manuals for Onkyo TX-NR717

Related product manuals