Onkyo TX-NR900E

Onkyo TX-NR900E

84 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

82

Memo

Table of Contents

Before Using Important Safeguards2
Precautions3
Contents4
- Table of Contents4
Features6
Supplied Accessories6
Before Using this Unit7
- Setting the Voltage Selector (Worldwide Models Only)7
- Connecting the Power Cord (Other than North American and Australian Models)7
- Installing the Remote Controller Batteries7
- Using the Remote Controller7
Index Parts and Facilities8
- Front Panels8
- Front Panel Display11
- Remote Controller12
- Rear Panels14
Connecting to Audio/Video Equipment16
- Connecting Your Audio Components17
- Connecting Your Video Components18
Connecting Speakers22
- Ideal Speaker Configuration22
- Minimum Speaker Configuration for Surround Sound Playback22
- Speaker Placement22
- Connecting Speakers23
- Using the Speaker Labels23
Connecting Antennas24
- Assembling the am Loop Antenna24
- Connecting the am Antenna Cable24
- Connecting the Included Antennas24
- Connecting an FM Outdoor Antenna25
- Connecting an am Outdoor Antenna25
- Directional Linkage25
- Connecting the Antenna Cable to the 75/300 Ω Antenna Adapter (for All Models Other than USA & Canadian Models and European Models)25
Connecting the Remote Zone (Zone 2) Speakers26
- When Using the ZONE 2 out Terminals26
- When Using the SURR BACK/ZONE 2 SPEAKERS Terminals26
- When Using the SURR BACK/ZONE 2 PRE out Terminals26
Operating Components Not Reached by the Remote Controller Signals (IR IN/OUT)27
- If the Remote Controller Signal Does Not Reach the TX-NR900/900E Remote Sensor27
- If the Remote Controller Signal Does Not Reach Other Components27
Miscellaneous Connections28
- Connections for Remote Control ( )28
- Connecting the Power Cords from Other Devices28
- RS 232 Port28
- Connecting to Devices with Analog Multi Channel Output29
- Connecting Auxiliary Power Amplifier29
- Connecting to an External Device with 12V TRIGGER Terminal29
Connecting the Power30
- Turning on the Power30
- Turning on the Power from the Remote Controller30
Enjoying Music or Videos with the TX-NR900/900E31
- Basic Operation31
- To Change the Display of the Input Source from TAPE to MD31
- Temporarily Turning off the Sound32
- Adjusting the Bass and Treble32
- Listening with Headphones32
- Using the Sleep Time (Remote Controller Only)32
- Changing the Listening Mode33
- Switching the Display34
- Adjusting the Brightness of the Front Display34
- Temporarily Changing the Speaker Output Levels34
- Changing the Audio Mode35
- Enjoying the Multichannel Output35
Listening to Radio Broadcasts36
- Tuning into a Radio Station36
- Listening to a Stereo Radio Station (FM Mode)36
- Presetting a Radio Station37
- Selecting a Preset Radio Station37
- Erasing a Preset Radio Station37
Listening to RDS Broadcasts38
- (European Models Only)38
- PTY Program Types in Europe38
- Displaying Radio Text (RT)39
- Performing a PTY Scan39
- Performing a TP Scan39
Recording a Source40
- To Record the Input Source Signal You Are Currently Watching or Listening to40
- To Record an Input Source Signal Different from that You Are Currently Watching or Listening to40
- Recording the Video from One Source and the Audio from Another41
Enjoying Music or Videos in the Remote Zone42
- Using the Buttons on the TX-NR900/900E42
- Using the Remote Controller43
- Adjusting the Volume for the Remote Zone43
Setup Menu44
- Navigating through the Setup Menu45
Hardware Setup46
- 0-1.Speaker Impedance Sub-Menu47
- AM Frequency Step Sub-Menu (Worldwide Model Only)47
- IR in Setup Sub-Menu47
- Surr Back/Zone 2 Sub-Menu47
- Hardware Setup Menu46
Speaker Setup48
- 1 Speaker Setup Menu48
- Speaker Config Sub-Menu48
- Speaker Distance Sub-Menu49
- Level Calibration Sub-Menu50
Input Setup51
- 2 Input Setup Menu51
- Digital Setup Sub-Menu (When NET AUDIO Is Not Selected as the Input Source)51
- Multichannel Setup Sub-Menu (When NET AUDIO Is Not Selected as the Input Source)52
- Character Input Sub-Menu53
- Video Setup Sub-Menu53
- Intellivolume Sub-Menu54
- Listening Mode Preset Sub-Menu54
Audio Adjust58
- 3 Audio Adjust Menu58
- Surround Speakers Sub-Menu58
- Tone Control Sub-Menu58
- Delay Sub-Menu59
- Sound Effect Sub-Menu59
- LFE Level Sub-Menu60
- Mono Sub-Menu60
- Theater-Dimensional Sub-Menu60
- Surround Sub-Menu61
- Enhanced 7/Orchestra/Unplugged/Studio MIX /TV Logic Sub-Menu62
- Logic Sub-Menu62
- THX Sub-Menu62
Preference64
- 4 Preference Menu64
- Volume Setup Sub-Menu64
- Headphones Level Sub-Menu65
- OSD Position Sub-Menu65
- OSD Setup Sub-Menu65
Remote Controller66
Using Remote Controller66
- Overview66
- Controlling an Onkyo Cassette Tape Deck66
- Controlling an Onkyo DVD Player67
- Controlling an Onkyo CD Player68
- Controlling an Onkyo MD Recorder69
Entering a Pre-Programming Code70
- Learning a Pre-Programming Code70
- Pre-Programming Codes71
Operating Your Programmed Remote Controller72
- DVD MODE (DVD Player Mode)72
- SAT MODE (Satellite Tuner Mode)72
- CABLE MODE (Cable Mode)72
- VCR MODE (VCR Mode)73
- TV MODE (TV Mode)73
Programming the Commands of Remote Controllers for Other Devices into the Remote Controller74
- Programming Procedure74
- Erasing the Programmed Command from One Button75
- Erasing All the Commands Programmed under a MODE Button75
Using the Macro Function76
- What Is the Macro Function76
- Programming the Macro76
- Executing the Macro76
- Erasing a Macro from the MACRO 1 (or 2) Button77
- Erasing All Commands and Macros that Have Been Programmed77
Appendix Troubleshooting Guide78
- Power78
- Speakers78
- Fm/Am Tuner78
- VIDEO and AUDIO79
- Remote Controller79
- Other79
- If One of the Messages Shown below Appears80
Specifications81

Other manuals for Onkyo TX-NR900E

Service Manual82 pages

Related product manuals

Preview: Onkyo TX-NR905

Preview: Onkyo TX-NR901

Preview: Onkyo TX-NR929

Preview: Onkyo TX-NR616

Preview: Onkyo TX-NR828

Preview: Onkyo TX-NR717

Preview: Onkyo TX-NR646

Preview: Onkyo TX-NR515

Preview: Onkyo TX-NR525

Preview: Onkyo TX-NR808

Preview: Onkyo TX-NR636

Preview: Onkyo TX-NR509