Playback
En-35
This section describes icons that appear on the AV
receiver’s display during media playback.
About the Bluetooth Wireless Technology
Bluetooth wireless technology is a short-range
wireless technology that enables wireless data
communication between digital devices. Bluetooth
wireless technology operates within a range of about
15 meters (49 feet). You do not need to use a cable
for connection, nor is it necessary for the devices to
face one another, such is the case with infrared
technology.
Tip
• The on-screen information appears only on a TV that is
connected to HDMI outputs.
• If your Bluetooth-enabled device supports A2DP protocol,
its audio file will play through the AV receiver.
• Connection is not guaranteed for all Bluetooth-enabled
devices.
Operating on the Remote Controller
The Bluetooth-enabled device can be operated by the
supplied remote controller.
Tip
• To operate your Bluetooth-enabled device by the remote
controller, the Bluetooth-enabled device must support
profile: AVRCP.
• Operation by the remote controller is not guaranteed for all
Bluetooth-enabled devices.
Pairing the AV receiver with a Bluetooth-
enabled device
Pairing is an operation where Bluetooth-enabled
devices register with each other beforehand. Use the
procedure below to pair the AV receiver with your
Bluetooth-enabled device. Once a pairing operation is
performed, it does not need to be performed again.
Understanding Icons on the Display
Icon Description
Folder
Track
Playback
Pause
Fast Forward
Fast Reverse
Artist
Album
Repeat One Track
Repeat Folder (USB Device)
Repeat
Shuffle
Playing an Audio from Bluetooth-
enabled Device
1
Place the Bluetooth-enabled device within
1 meter (3.3 feet) from the AV receiver.
2
Select “BLUETOOTH” in “Input” in Quick
Setup, and press ENTER (➔ page 57).
BLUETOOTH indicator flashes and the AV
receiver is put to pairing mode.
“Now Pairing” appears on the AV receiver’s
display.
Tip
• The same operation can be done by pressing
BLUETOOTH button on the AV receiver.
• When connecting a Bluetooth-enabled device paired
with the AV receiver to the AV receiver,
“BLUETOOTH” input selector is automatically
selected.
• If you connect the AV receiver to another Bluetooth-
enabled device, hold down BLUETOOTH button until
BLUETOOTH indicator flashes or make settings in
“Status” of “Bluetooth” for pairing (➔ page 81).
• Some Bluetooth-enabled device may need to re-
establish pairing for each connection.
Note
•“BLUETOOTH” cannot be selected, if you’ve selected
NET or USB as input selector in Multi Zone.
To Next Page
Loading...
