22
7. Multi-zone Connection-3 (ZONE
SPEAKER)
You can enjoy 2ch audio in the separate room by, for
example, playing a Blu-ray Disc player in the main room
(where this unit is located) and listening to internet radio
through the speakers in the separate room (ZONE 2).
0 You cannot use ZONE SPEAKER if you have connected
the front speakers using Bi-Amping connection.
0 No sound is played from the surround back speakers or
the height speakers when playing audio from ZONE
SPEAKER.
ZONE 2 (ZONE 2A for North American models)
Connect with HDMI IN 1 to 3 if you want to output an
external AV component to ZONE 2. If the AV component
doesn't have an HDMI jack, connect using a digital optical
cable, digital coaxial cable, or analog audio cable.
(North American models) ZONE 2B
You can output the same audio as described in ZONE 2A
with another set of speakers to output as ZONE 2B. In this
case, connect speakers with 8
Ω
to 16
Ω
impedance for
ZONE 2 A/B. These cannot be connected when surround
back speakers or height speakers are connected.
Setup
0 Settings are required in Initial Setup, "4. Multi
Zone Setup" (P25) to enjoy this feature.
0 To use the ZONE 2A+B output, set "Zone
Speaker" in "1. AccuEQ Room Calibration"
(P24) in Initial Setup to "Zone 2 A + B".
0 The audio from externally connected AV
components can only be output when the audio
is analog or 2ch PCM audio signals. If you have
connected to this unit with an HDMI cable or
digital optical/coaxial cable, may be necessary
to convert the audio output of the AV component
to PCM output.
SN29402783_TX-RZ720_BAS_En_1703XX.book 22 ページ ２０１７年３月２０日 月曜日 午前１０時４５分
To Next Page
Loading...
