Onkyo TX-RZ720 - 8. Connect Other Cables

23
8. Connect Other Cables
Antenna Hookup
Move the antenna around while playing the radio to find the
position with the best reception. Use a thumb tack or similar
to attach the indoor FM antenna to a wall.
Network Hookup
Connect this unit to the network using wired LAN or Wi-Fi
(wireless LAN). You can enjoy network features such as
internet radio by connecting the unit to the network. If you
connect by wired LAN, connect with an Ethernet cable to
the ETHERNET port as shown in the illustration. To connect
by Wi-Fi, then after selecting "Wireless" in "3. Network
Connection" (P25) in Initial Setup, select the desired setting
method and follow the onscreen instructions to configure
the connection.
Power Cord Hookup
The power cord must be connected only after all other
cable connections are completed.
0 North American, European and Asian models include a
removable power cord. Connect the power cord to AC
INLET of the unit and then connect to the outlet. Always
disconnect the outlet side first when disconnecting the
power cord.
> Before Start > Part Names >Install > Initial Setup > Playback
c
d
a
bb
(North American
models)
(European,
Australian and
Asian models)
(Australian
models)
a AM loop antenna, b Indoor FM antenna, c Ethernet cable, d Power cord
En
SN29402783_TX-RZ720_BAS_En_1703XX.book 23 ページ ２０１７年３月２０日 月曜日 午前１０時４５分