Need help?Do you have a question about the Onkyo TX-8211 and is the answer not in the manual?
General| Frequency Response | 10 Hz-100 kHz (+1 dB, -3 dB) |
|---|---|
| Signal-to-Noise Ratio | 100 dB (Line) |
| Tuning Range | FM, MW |
| Power Output | 50 W per channel (8 ohms, 20 Hz-20 kHz, 0.08% THD) |
| Total Harmonic Distortion | 0.08% |
| Dimensions | 435 x 141 x 314 mm |
| Input Sensitivity | 200mV (line) |
| Speaker Load Impedance | 4-16 ohms |
Details power output, distortion, damping factor, and input sensitivities.
Covers tuning ranges, sensitivity, selectivity, and signal-to-noise ratios.
Includes power supply, dimensions, weight, and remote control details.
Instructions for replacing fuses with correct types and ratings.
Procedure to reset the unit to factory settings via microprocessor.
Essential safety check after service for U.S.A. models using an insulating-resistance tester.
Guide for changing the unit's voltage setting for different power supplies.
Information on the unit's built-in memory back-up system and its operation.
How to adjust the AM tuning step frequency for different regions.
Procedure for changing band step by component modification.
Lists chassis, panels, covers, and knobs with part numbers.
Details internal parts like transistors, ICs, and circuit boards by part number.
Details required inputs and signal generator settings for adjustments.
Specifies load connections for speaker terminals during adjustments.
Specifies default positions for control knobs during adjustments.
Step-by-step guide to set the idling current for the amplifier.
Detailed steps for tuning and aligning the FM receiver section.
Detailed steps for tuning and aligning the AM receiver section.
Detailed parts list for the main circuit board (NAAR-5864).
Detailed parts list for the power supply board (NAETC-5866).
Detailed parts list for the volume control board (NAETC-5865).
Detailed parts list for the display circuit board (NADIS-5871).
To Next Page
