25
> Network Functions > Specifications > Advanced Setup > Listening Modes
Troubleshooting Supplementary Information, etc�|
> Basic Manual
when the network feature is started.
■ 5� 12V Trigger
Setting Item Default Value Setting Details
Zone Main Set which zone to output the 12V trigger when
playing. If you select "All", then the 12V trigger is
output to all zones that are playing.
6� Multi Zone
Make settings related to Multi-zone Connection, such as the volume for the separate room.
■ 1� Zone 2
Setting Item Default Value Setting Details
Output Level Fixed Select whether to adjust the volume on the pre-
main amplifier in the separate room or on this unit
when outputting to Zone 2.
"Fixed": Adjust on the pre-main amplifier in the
separate room
"Variable": Adjust on this unit
Maximum Volume Off Set the maximum value for Zone 2 to avoid too
high volume. Select a value from "Off", "50" to
"99". (When "3. Audio Adjust" - "Volume" - "Volume
Display" is set to "Absolute")
Power On Volume Last Set the Zone 2 volume level of when this unit is
turned on. Select a value from "Last" (Volume level
when the unit was turned off), "Min", "0.5" to "99.5"
and "Max". (When "3. Audio Adjust" - "Volume" -
"Volume Display" is set to "Absolute")
•
You cannot set a higher value than that of
"Maximum Volume".
■ 2� Zone 3
Setting Item Default Value Setting Details
Output Level Fixed Select whether to adjust the volume on the pre-
main amplifier in the separate room or on this unit
when outputting to Zone 3.
"Fixed": Adjust on the pre-main amplifier in the
separate room
"Variable": Adjust on this unit
Maximum Volume Off Set the maximum value for Zone 3 to avoid too
high volume. Select a value from "Off", "50" to
"99". (When "3. Audio Adjust" - "Volume" - "Volume
Display" is set to "Absolute")
To Next Page
Loading...
