Onn ONB13AV004 - Battery Installation

3
Your universal remote requires two (2) AAA
Alkaline batteries (not included).
To Install the Batteries:
1. Remove the battery compartment cover by
sliding the cover down.
2. Match the (+) and (-) marks on the batteries
to the (+) and (-) marks inside the battery
compartment, then insert two (2) AAA Alkaline
batteries. Be sure to use fresh batteries.
3. Slide the battery compartment cover back
into place.
Note: If your remote stops operating properly,
replace the batteries with new ones. The remote
will retain the codes you have programmed for up
to 10 minutes after the batteries are removed.
Battery Precautions:
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc),or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
• Alwaysremoveold,weakorworn-outbatteries
promptly and recycle or dispose of them in
accordance with local and national regulations.
Care and Maintenance
• Keeptheremoteawayfrommoisture.Ifitgets
wet, dry it immediately.
• Useandstoretheremoteatnormal
household temperatures.
• Useasoft,dampclothtocleantheremote.
• Iftheremoteisnotgoingtobeusedfora
long period of time, remove the batteries
from the remote.
• Handletheremotewithcare.
Battery Installation