To Next Page

To Previous Page

Programming Your Remote

Your ONN universal remote control is designed to

control up to 4 different audio/video devices such

as TV, DVD, VCR, satellite, cable and audio using

only one remote. To use this remote, you will need

to program it to control the devices of your choice.

There are two ways to program the remote - direct

code entry or auto code search.

Direct Code Entry (Recommended)

1. Locate the Remote Code List

provided in this manual. Find the

DEVICE CATEGORY you wish to

program(forexampleTV, DVD,

SAT, AUX)andthenndthe

BRAND of that device. Circle all the

codesunderthatbrand.Example:

For a GE TV, locate the TV code

section then circle all of the GE TV

codes.

2. Manually turn on the device you

wish to control.

3. Press and hold the SETUP button

until the red indicator light stays on

(approximately2seconds)andthen

release the SETUP button.

4. Press and release the desired device

button on the remote (TV, DVD,

SAT, AUX). The red indicator will

blink once and then remain on.

5. Entertherst4-digitcodepreviously

found in the code list using the

number buttons on the remote. If

the code entered is a valid code, the

red indicator light will turn off. If the

code entered is not a valid code, the

redindicatorlightwillashand

remain on allowing you to re-enter

the code.

Note: If no buttons are pressed for

35 seconds, the remote will exit the

SETUP mode and you will have to

Onn ONB13AV004 User Manual

Questions and Answers: