HOBO Wireless
Data Node Setup Guide
This Setup Guide is intended to help you get a receiver and one
data node up and running so you can get familiar with the
hardware and software. You will supply power to the receiver
and the data node, connect the receiver to your computer, and
then add the data node to the network.
Once you are familiar with the basic setup tasks, you can go
back and add additional data nodes and perform advanced
configuration if required.
IMPORTANT
Do not install batteries into devices until
you are instructed to in this guide.
Tools Required
• Wire paper clip
Onset Computer Corporation
2
Task 1: Install HOBOware
®
and Start
HOBOnode Manager
NOTE: If you already have HOBOware installed, start it
now and proceed to Step B.
A. Insert the HOBOware CD in your computer's CD drive
and follow the prompts to install the software.
HOBOware should open automatically when the
installation is complete.
B. From the HOBOware Main Menu, select Device >
Manage HOBO Data Node Network.
C. Click Yes when prompted by the following window:
Next Task: Supply Power to the Receiver
To Next Page
