______________________________________________________________________________________
FOR SAFETY (cont.):
4. Before leaving or servicing machine:
• Stop on level surface.
• Set the parking brake, if equipped.
• Turn off machine and remove key.
5. When servicing machine:
• Disconnect battery connection and
charger cord before working on machine.
• All work must be done with sufficient
lighting and visibility.
• All repairs must be performed by trained
personnel.
• Use Tennant supplied or approved
replacement parts.
• Do not modify the machine from its
original design.
• Do not jack up machine.
• Avoid moving parts. Do not wear loose
clothing or jewelry and secure long hair.
• Do not disconnect the off- board
charger’s DC cord from the machine’s
receptacle when the charger is
operating. Arcing may result. If the
charger must be interrupted during
charging cycle, disconnect the AC power
supply cord first.
• Do not use incompatible battery
chargers as this may damage battery
packs and potentially cause a fire hazard.
• Inspect charger cord regularly for
damage.
• Keep work area well ventilated.
• Avoid contact with battery acid.
• Keep all metal objects off batteries.
• Do not power spray or hose off machine.
• Use a hoist or adequate assistance when
lifting batteries.
• Battery installation must be done by
trained personnel.
• Wear personal protection equipment as
needed and where recommended in this
manual.
6. When loading/unloading machine onto/off
truck or trailer:
• Drain tanks before loading machine.
• Use a ramp, truck or trailer that can
support the machine weight and
operator.
• Do not operate the machine on a ramp
incline that exceeds a 5% grade level.
• Use a winch if ramp incline exceeds a 5%
grade level.
• Lower the scrub head and squeegee
before tying down machine.
• Turn machine off and remove key.
• Set parking brake (if equipped).
• Block machine wheels.
• Use tie- down straps to secure machine.
To Next Page
Loading...
Need help?
General
