Med PC MedPC-5500
31
3.1BIOS Setup Program
This motherboard supports a programmable firmware chip that you
can update using the provided utility. Use the BIOS Setup program
when you are installing a motherboard, reconfiguring your system,
or prompted to “Run Setup.” This section explains how to configure
your system using this utility.
Even if you are not prompted to use the Setup program, you can
change the configuration of your computer in the future. For
example, you can enable the security password feature or change
the power management settings. This requires you to reconfigure
your system using the BIOS Setup program so that the computer
can recognize these changes and record them in the CMOS RAM
of the firmware hub.
The firmware hub on the motherboard stores the Setup utility. When
you start up the computer, the system provides you with the
opportunity to run this program. Press <Del> during the
Power-On-Self-Test (POST) to enter the Setup utility; otherwise,
POST continues with its test routines.
If you wish to enter Setup after POST, restart the system by
pressing
To Next Page
Loading...