WorkBee CNC Limit Switches & Wire Routing 13
2.2.6 Belt Driven - Y-Axis Wire Routing
A. Connect a stepper motor wire to the pigtail on the left hand Y-Axis stepper motor (if
looking from the front) and feed it through the square hole on the Y-Plate
B. Inside the Y-Drag-Chain there should be a power supply wire (yellow above), and a
limit switch wire (green above). Feed all of these through the square hole on the Y-
Plate. Remove any slack inside the Y-Drag-Chain, and then secure these 2 wires to the
Y-Drag-Chain-Moving-End-Mount using Cable-Tie-Smalls.
To Next Page
Loading...
