ooznest WorkBee CNC - Default Chapter; Table of Contents

WorkBee CNC 1
Table of Contents
1.0 Getting Started 3
1.1 Notes on Assembly 4
2.0 Limit Switches & Wire Routing 5
2.1 Limit Switches 6
2.1.2 Z-Axis Limit Switch...................................................................... 8
2.2 Wire Routing 9
2.2.2 Screw Driven - Gantry Wire Routing ............................................ 10
2.2.3 Belt Driven - Gantry Wire Routing ............................................... 11
2.2.4 Screw Driven - Y-Axis Wire Routing - Part 1 .................................. 12
2.2.5 Screw Driven - Y-Axis Wire Routing - Part 2 .................................. 13
2.2.6 Belt Driven - Y-Axis Wire Routing ................................................ 14