Vehicle care 181
7. Fit seal on bulb holder. Ensure
that the seal is flat in the area of
the screws.
8. Engage plug. Insert bulb housing
in body, ensuring proper
positioning of the ball pins in the
recesses. Tighten the retaining
nuts.
Side turn signal lights
Have the bulbs replaced by
a workshop.
Number plate light
1. Insert a screwdriver in the
housing, press to the side and
release spring.
2. Remove bulb housing
downwards, taking care not to pull
on the cable.
3. Lift flap and disconnect wiring
plug from bulb holder.
To Next Page
Loading...
